Studies on Mixed Flow Propeller Pumps : Part 2. Effects of Vane Roughness and Vane Thickness
نویسندگان
چکیده
منابع مشابه
the effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
Evaluation of Composite Vane Materials for Rotary Sliding Vane Compressors
The physical performance characteristics of composite materials used for vanes in rotary, sliding-vane compressors, in general, are several orders of magnitude more difficult to quantify for design purposes than most homogeneous materials. This arises from the numerous variables that influence the response of these materials under the severe environmental conditions existing in such compressors...
متن کاملVane Dynamics Analysis of a Tilted Vane Rotary Compressor
An analytical model of vane dynamics in a tilted vane rotary compressor is presented. With the geometric relationship of the vane in a tilted slot, and the roller, the kinetic equations were derived for evaluating the reciprocating inertial force of the vane, and the chamber volume equations were obtained for calculating pressure history inside the compression chamber. The empirical friction co...
متن کاملEffects of Vane Spring Stiffness on Compressor Performance
This study presents effects of the vane spring stiffness on frictional power characteristics of a refrigeration compressor. Comparisons on the compressor performance are investigated for different vane spring stiffnesses with compressors designed with high and low shell pressures. Results show that while compressors with a low shell pressure using a higher spring stiffness combination may reduc...
متن کاملVane Behavior in Vane Compressors Under Start-up Operation
Vane oompressors can not maintain contact between a vane tip and a cylinder wall under start-up operation since backpressure acting on the vane is not sufficient. We theoretically analyzed transient behavior of the vane under the start-up operation by taking account of changes of the backpressure and discharge pressure after compression starting. The validity of the theoretical analysis was con...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1965
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.31.286