STUDIES ON CEMENTITE CRACKS OF HIGH CARBON STEEL (I)
نویسندگان
چکیده
منابع مشابه
Load partitioning between ferrite and cementite during elasto-plastic deformation of an ultrahigh-carbon steel
An ultrahigh-carbon steel was heat-treated to form an in situ composite consisting of a fine-grained ferritic matrix with 34 vol.% submicron spheroidized cementite particles. Volume-averaged lattice elastic strains for various crystallographic planes of the a-Fe and Fe3C phases were measured by synchrotron X-ray diffraction for a range of uniaxial tensile stresses up to 1 GPa. In the elastic ra...
متن کاملAn Analytical Electron Microscopy Study of Paraequilibrium Cementite Precipitation in Ultra-High-Strength Steel
To support quantitative design of ultra-high-strength (UHS) secondary-hardening steels, the precipitation of cementite prior to the precipitation of the M2C phase is investigated using a model alloy. The microstructure of cementite is investigated by transmission electron microscopy (TEM) techniques. Consistent with earlier studies on tempering of Fe-C martensite, lattice imaging of cementite s...
متن کاملElectrochemical and Dry Sand Impact Erosion Studies on Carbon Steel
This study investigated the dry and aqueous erosion of mild steel using electrochemical and dry sand impact techniques. In dry sand impact experiments, mild steel was eroded with 45 μm and 150 μm sand particles. Scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX) and micro-hardness techniques were used to elaborate the surface morphology of the eroded samples. The res...
متن کاملQuality of High Density Polyethylene on Plain Carbon Steel and the Role of Primers
In this paper 
, the effect of curing time and temperature as well as various primers on durability of high density polyethylene on plain carbon steel have been investigated. The aim is to increase adhesion, improve durability and also to produce a defect-free in order to improve the corrosion resistance of steel substrate. For this purpose, after surface preparation and applying a primer (z...
متن کاملLaser Grooving of Surface Cracks on Hot Work Tool Steel
Repair welding (RW) with wire cladding is a common procedure to extend the in-service life of heavily loaded tool parts for die and mould industries 1-5 . The main advantages of repair welding are short downtime and cost efficiency compared to production of new tool part. Repair welding in general lowers the tool cost in the final part and enables higher added value to the die casting and injec...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Tetsu-to-Hagane
سال: 1956
ISSN: 0021-1575,1883-2954
DOI: 10.2355/tetsutohagane1955.42.12_1111