Structure of InSb-FeSb and InSb-CrSb Eutectic Alloys by Directional Solidification
نویسندگان
چکیده
منابع مشابه
Mathematical and Physical Modelling of Directional Solidification of Aerospace Alloys
Defect formation in aerospace components is studied, particularly in regions of directionally solidified casting with stepwise increase in cross-section, which is a typical geometric configuration for such components as turbine blades. Given the fact that the geometry of a casting is directly related to probability of defect formation, special attention was paid to grain defects in regions of c...
متن کاملInSb films for magnetic sensors
InSb films are prepared by a source-temperature-programmed evaporation method and hot-wire recrystalhzatlon lnethod for Hail elements and ma~etor~~stan~ (MR) elements, respecttvely, to reduce nnperfectJons of the crystal structure, and their crystakne and electrical propertles are studied An optimum source-temperature pmgramme 1s mvestlgated and the films thus prepared are used for Hall element...
متن کاملInteraction of Mn with GaAs and InSb
The deposition of Mn on to reconstructed InSb and GaAs surfaces, without coincident As or Sb flux, has been studied by reflection high energy electron diffraction, atomic force microscopy and scanning tunnelling microscopy. On both Gaand As-terminated GaAs(0 0 1), (2× n) Mn-induced reconstruction domains arise with n = 2 for the most well ordered reconstructions. On the Ga-terminated (4× 6), th...
متن کاملThe formation of high number density InSb quantum dots, resulting from direct InSb/GaSb (001) heteroepitaxy
We report the direct deposition of indium antimonide, by molecular beam epitaxy (MBE) on gallium antimonide, resulting in the formation of quantum dots (QDs) with a maximum density of 5.3 10 cm . Using reflection high energy electron diffraction (RHEED) and atomic force microscopy (AFM) for the analysis of samples with InSb depositions of 1–6 ML equivalent thickness, we observe an apparent valu...
متن کاملGrowth of high quality, epitaxial InSb nanowires
The growth of InSb nanowires on an InSb(1 1 1) substrate in a closed system is described. A high density InSb nanowires was grown by the use of InSb substrates in a torch sealed quartz tube at a temperature of 400 1C, using a 60 nm size gold colloid catalyst. The typical diameter of the InSb nanowires was 80–200 nm and they consisted of nearly equal atomic percent of In and Sb. Transmission ele...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1974
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.38.1_42