Structure of Fe-Mn-Al-C Steels after Gleeble Simulations and Hot-Rolling
نویسندگان
چکیده
منابع مشابه
STUDY OF THE STRUCTURE OF INTERMETALICS FROM Fe - Al SYSTEM AFTER THE HOT ROLLING
M. Jabłońska, I. Bednarczyk, K. Rodak, A. Śmiglewicz Silesian University of Technology, Faculty of Materials Science and Metallurgy, Institute of Materials Science Katowice, Poland This paper presents the results of structure analysis of Fe Al alloys after hot rolling deformation. Microstructure analysis were performed before and after deformation using a scanning transmission electron microsco...
متن کاملStudy on Oxidation of Stainless Steels During Hot Rolling
The oxidation of stainless steels 304 and 304L during hot rolling is studied in this paper. Results show the oxide scale thickness decreases significantly with an increase of reduction, and the oxide scales of both 304 and 304L stainless steels were found more deformable than the steel substrate. Surface roughness shows a complicated transfer during the hot rolling process due to the complexity...
متن کاملKinetics of Austenite Recrystallization during the Annealing of Cold-rolled Fe-Mn-Al-C Steel
In the current study, the recrystallization behavior of 75% cold-rolled Fe-22Mn-10Al-1.4C steel during annealing at 750, 770, 790, 810, and 830°C was studied. X-ray diffraction patterns and optical microscopy were used to characterize microstructures. The Vickers Micro-hardness test was used to characterize recrystallization kinetics during annealing. Johnson-Mehl-Avrami-Kolmogorov (JMAK) model...
متن کاملMagnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling
The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...
متن کاملEffect of Composition on the Recrystallization Behavior of if Steels During Simulated Hot Strip Rolling
Flow curves are generated in muti-pass torsion tests for a titanium stabilized and a niobium stabilized IF steel. Two types of test schedule are used, one based on plate rolling and the other approximating strip rolling. The purpose of the former is to define the three critical temperatures of steel rolling. The strip schedules are varied in order to investigate the influence of increasing the ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials
سال: 2020
ISSN: 1996-1944
DOI: 10.3390/ma13030739