Structure of Direct RF Sampling Receivers for GNSS Signals
نویسندگان
چکیده
منابع مشابه
CMOS RF Notch Filter for GNSS Receivers
Bandpass sampling architectures, also called subsampling architectures, exhibit several advantages over super-het architectures. First, the complexity of subsampling architectures is significantly lower since no Phased-Locked-Loop (PLL) is required. A direct consequence is that downconversion from RF to IF can be achieved with significant power savings as compared to the super-het architecture....
متن کاملA checklist for designing RF-sampling receivers
The modern, advanced CMOS direct radio frequency (RF)-sampling data converter has been eagerly awaited by system design engineers for several major end-equipment manufacturers. This includes manufacturers of communications infrastructure, software-defined radios (SDRs), radar systems, or test and measurement products. Recently introduced data converters are delivering the high dynamic range com...
متن کاملMonolithic Integrated RF Front ends for Multi-GNSS receivers
The continuing expansion of available GNSS signals is an increasing challenge for receiver designers. New signals with expanded bandwidths are demanding greater sampling rates that require careful design of the receiver RF section to maximise performance tradeoffs. A high level of integration is required to preserve signal path integrity and minimise noise while keeping power consumption to a m...
متن کاملDirect bandpass sampling of multiple distinct RF signals
A goal in the software radio design philosophy is to place the analog-to-digital converter as near the antenna as possible. This objective has been demonstrated for the case of a single input signal. Bandpass sampling has been applied to downconvert, or intentionally alias, the information bandwidth of a radio frequency (RF) signal to a desired intermediate frequency. The design of the software...
متن کاملDirect downconversion of multiple RF signals using bandpass sampling
The center idea behind the software radio architecture is to place analog-to-digital and digital-to-analog converters as near the antenna as possible, leaving the implementation of the most radio functionality to a programmable micro or signal processor. One way to accomplish this in a radio receiver front end is by direct downconverting the desired radio frequency (RF) signal to a target inter...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Positioning, Navigation, and Timing
سال: 2014
ISSN: 2288-8187
DOI: 10.11003/jpnt.2014.3.3.091