Structure and tensile properties evaluation of samples produced by Fused Deposition Modeling
نویسندگان
چکیده
منابع مشابه
Nanostructured Al–Fe alloys produced by e-beam deposition: static and dynamic tensile properties
Three different aluminum–iron alloys were produced by electron-beam deposition with the iron content in the range 1.15–1.71 at.%. These alloys did not contain any identifiable iron-bearing particles, and exhibited full density with high-angle grain boundaries in the micrometer range, and a sub-grain size typically smaller than 100 nm. The tensile deformation characteristics of the alloys were e...
متن کاملMethods to Improve Surface Finish of Parts Produced by Fused Deposition Modeling
Fused deposition modeling (FDM) is one of the rapid prototyping technologies that can use plastic material, which can be effectively used for making patterns for investment casting. The surface finish of the investment casting depends upon the surface finish of the pattern. But the surface finish of the parts produced by using FDM is not very good as compared to wax patterns, which are conventi...
متن کاملCurved Layer Fused Deposition Modeling
Current Fused Deposition Modeling (FDM) technologies deposit material as flat layers. The result is a “stair-case” effect on non-vertical or horizontal surfaces, and compromised part strength because of weakness between the laminations. This paper describes a FDM method through which layers of build material are deposited as curved layers following the shape of the part, thus removing the stair...
متن کاملcontrol of the optical properties of nanoparticles by laser fields
در این پایان نامه، درهمتنیدگی بین یک سیستم نقطه کوانتومی دوگانه(مولکول نقطه کوانتومی) و میدان مورد مطالعه قرار گرفته است. از آنتروپی ون نیومن به عنوان ابزاری برای بررسی درهمتنیدگی بین اتم و میدان استفاده شده و تاثیر پارامترهای مختلف، نظیر تونل زنی(که توسط تغییر ولتاژ ایجاد می شود)، شدت میدان و نسبت دو گسیل خودبخودی بر رفتار درجه درهمتنیدگی سیستم بررسی شده اشت.با تغییر هر یک از این پارامترها، در...
15 صفحه اولTensile Properties Characterization of AlSi10Mg Parts Produced by Direct Metal Laser Sintering via Nested Effects Modeling
A statistical approach for the characterization of Additive Manufacturing (AM) processes is presented in this paper. Design of Experiments (DOE) and ANalysis of VAriance (ANOVA), both based on Nested Effects Modeling (NEM) technique, are adopted to assess the effect of different laser exposure strategies on physical and mechanical properties of AlSi10Mg parts produced by Direct Metal Laser Sint...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Open Engineering
سال: 2016
ISSN: 2391-5439
DOI: 10.1515/eng-2016-0011