Structure Analysis of Rapidly Solidified Al-Fe Alloy Foils Produced by the Planar Flow Casting Method
نویسندگان
چکیده
منابع مشابه
Magnetic Properties of Pr–Fe–Al Alloys Produced by the Metallic Mold Casting Method
The structures and magnetic properties of Pr–Fe–Al alloys produced by the metallic mold casting method were investigated. The Pr–Fe–Al alloy consisted of the amorphous phase together with the non-ferromagnetic Pr phase. Magnetic measurements confirmed that the origin of coercivity in the alloys was the amorphous phase. It was found that the Curie temperature and coercivity of the alloys were st...
متن کاملMICROSTRUCTURE OF A RAPIDLY SOLIDIFIED Al-4V-2Fe ULTRAHIGH STRENGTH ALUMINUM ALLOY
Microstructure of a rapidly solidified Al-4V-2Fe alloy has been examined in detail by means of transmission electron microscopy and atom probe field ion microscopy. It is composed of a mixture of α-Al and amorphous phases. α-Al grains are relatively large (400 nm), but nanoscale domains of amorphous phase are trapped in the fcc grains. The interface between the α-Al and amorphous phases are ver...
متن کاملthe effects of changing roughness on the flow structure in the bends
flow in natural river bends is a complex and turbulent phenomenon which affects the scour and sedimentations and causes an irregular bed topography on the bed. for the reason, the flow hydralics and the parameters which affect the flow to be studied and understand. in this study the effect of bed and wall roughness using the software fluent discussed in a sharp 90-degree flume bend with 40.3cm ...
New development of rapid-solidified Fe-Ga sensor/actuator alloy
Rapid-solidification method was applied to make Fe-15at%Ga and Fe-17at%Ga ribbons of 100 μm thickness. These ribbons have large magnetostriction of 270 ppm, where the coercive force exhibits a maximum value. The phenomenon is related to special metallic texture, that is, the ribbon has strongly [001]-oriented textured fine columnar microstructure with grain size of 2~5 μm. The ribbon has little...
متن کاملOptimization of Microstructure and Mechanical Properties of Al-A360 Produced by Semi-Solid Casting
Semi-Solid Casting (SSM) is a new process that could produce globular structures with mechanical properties. The cooling slope method (CLM) is a one of this process that was employed to produce the A360 feedstock. In this method, The dendritic primary phase in the conventionally cast A356 alloy has transformed into a non-dendritic one. In this paper, The molten alloy with the temperature (PT) o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1994
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.58.12_1460