Structural Transition in SrZnO Laser Pulse Deposited Alloy
نویسندگان
چکیده
منابع مشابه
Magnetic and structural properties of pulsed laser deposited CuFe2O4 films
Highly crystal textured copper ferrite films have been grown on s100d MgO substrates using pulsed laser deposition. Deposition temperatures were varied from 600–900 °C, with deposition oxygen pressure varied from 1 mTorr to 120 mTorr. Saturation magnetization was measured to increase monotonically with substrate temperature approaching the bulk value of 1700 G near 900 °C. Magnetization was als...
متن کاملHeat Transfer in Semitransparent Medium Caused by Laser Pulse
In this paper, the combination of conduction with radiation into a semitransparent medium which includes absorption, emission and scattering has been investigated. In order to Study the conduction in medium, the Non-Fourier heat conduction has been applied. In this model there is a time delay between heat flux and temperature gradient. Also, in contrast with Fourier heat conduction, the speed o...
متن کاملCr13Ni5Si2-Based Composite Coating on Copper Deposited Using Pulse Laser Induction Cladding
A Cr13Ni5Si2-based composite coating was successfully deposited on copper by pulse laser induction hybrid cladding (PLIC), and its high-temperature wear behavior was investigated. Temperature evolutions associated with crack behaviors in PLIC were analyzed and compared with pulse laser cladding (PLC) using the finite element method. The microstructure and present phases were analyzed using scan...
متن کاملComprehensive study of the metal-insulator transition in pulsed laser deposited epitaxial VO2 thin films
deposited epitaxial VO2 thin films Deyi Fu, Kai Liu, Tao Tao, Kelvin Lo, Chun Cheng, Bin Liu, Rong Zhang, Hans A. Bechtel, and Junqiao Wu Department of Materials Science and Engineering, University of California, Berkeley, California 94720, USA Jiangsu Provincial Key Laboratory of Advanced Photonic and Electronic Materials, School of Electronic Science and Engineering, Nanjing University, Nanji...
متن کاملMachinability evaluation of Titanium alloy in Laser Assisted Turning
The use of titanium and its alloys has increased in various industries recently, because of their superior properties of these alloys. Titanium alloys are generally classified as difficult to machine materials because of their thermo-mechanical properties such as high strength-to-weight ratio and low thermal conductivity. Laser Assisted Machining (LAM) improves the machinability of high strengt...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Archives of Metallurgy and Materials
سال: 2017
ISSN: 2300-1909
DOI: 10.1515/amm-2017-0030