منابع مشابه
Structural transition and enhanced phase transition properties of Se doped Ge2Sb2Te5 alloys
Amorphous Ge₂Sb₂Te₅ (GST) alloy, upon heating crystallize to a metastable NaCl structure around 150°C and then to a stable hexagonal structure at high temperatures (≥250°C). It has been generally understood that the phase change takes place between amorphous and the metastable NaCl structure and not between the amorphous and the stable hexagonal phase. In the present work, it is observed that t...
متن کاملStructural Phase Transformation and Phonon Softening in Iron-Based Alloys
The interrelation of Invar and Martensite in iron-based alloys like Fe3Ni is discussed on the basis of ab initio calculations for different crystal structures. Inelastic neutron scattering and ultrasonic experiments have shown that a soft transverse phonon mode in [110] direction acts as a precursor in the close packed fcc phase of these systems. Unfortunately there are no experimental results ...
متن کاملStructural phase transition in epitaxial perovskite films
Three different film systems have been systematically investigated to understand the effects of strain and substrate constraint on the phase transitions of perovskite films. In SrTiO3 films, the phase transition temperature Tc was determined by monitoring the superlattice peaks associated with rotations of TiO6 octahedra. It is found that Tc depends on both SrTiO3 film thickness and SrRuO3 buff...
متن کاملStructural Phase Transition Accompanied by Metal - Insulator Transition in PrRu4P12
A structural phase transition has been found using electron diffraction technique in PrRu4P12 accompanied by a metal insulator (M I) transition (TMI = 60K). Weak superlattice spots appeared at (H, K, L) (H + K + L = 2n + 1; n is an integer) position at a temperature of T = 12 K and 40 K. Above T = 70 K, the spots completely vanished. The space group of the low temperature phase is probably Pm 3...
متن کاملStress Induced Phase Transition of Iron-Rhodium Alloys
Stress-induced phase transitions(B2-Llo, B2-fcc) on an FeRh alloy were investigated with X-ray diffraction (XRD) and transmission electron microscopy(TEM). An Fe-SO.Sat%Rh alloy was rolled to 80pm thickness, and annealed at 1370K for 173ks. Annealed sample sheets were cold rolled at various rolling rates, and changes of the sample alloy on the phase state were investigated with XRD. The L lo ph...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2010
ISSN: 1742-6596
DOI: 10.1088/1742-6596/251/1/012027