Stress–Strain Model for Low-Strength Concrete in Uni-Axial Compression
نویسندگان
چکیده
منابع مشابه
High Strength Concrete Columns under Axial Compression Load: Hybrid Confinement Efficiency of High Strength Transverse Reinforcement and Steel Fibers
Addition of steel fibers to high strength concrete (HSC) improves its post-peak behavior and energy absorbing capability, which can be described well in term of toughness. This paper attempts to obtain both analytically and experimentally the efficiency of steel fibers in HSC columns with hybrid confinement of transverse reinforcement and steel fibers. Toughness ratio (TR) to quantify the confi...
متن کاملA device for simultaneous live cell imaging during uni-axial mechanical strain or compression.
Mechanical stimuli control multiple cellular processes such as secretion, growth, and differentiation. A widely used method to investigate cell strain ex vivo is stretching an elastic membrane to which cells adhere. However, simultaneous imaging of dynamic signals from single living cells grown on elastic substrates during uni-axial changes of cell length is usually hampered by the movement of ...
متن کاملA mathematical model for optimization of strength of concrete: A case study for shear modulus of Rice Husk Ash Concrete
Rice Husk Ash (RHA) is natural Pozzolan containing reactive silica and/or aluminum. When the material is mixed with lime in powdered form and in the presence of water, it will set and harden like cement. This work uses Osadebe’s optimization model to optimize the shear modulus of concrete made from RHA. The strengths predicted by the model are in good agreement with their corresponding experime...
متن کاملLow Porosity, High Strength Concrete for Bridge Decks
IN TR O D U CTIO N -TH E PROBLEM A few years ago a problem that previously had been a modest highway maintenance concern suddenly became a major source of dif ficulty and expense to highway departments in many areas of the coun try; including Indiana. In brief, concrete bridge decks, some new, started to spall, then delaminate, then come apart in relatively large chunks. The problem was quick...
متن کاملTest and Analysis of a Composite Multi-bay Fuselage Panel under Uni-axial Compression
A composite panel containing three stringers and two frames cut from a vacuum-assisted resin transfer molded (VaRTM) stitched fuselage article was tested under uni-axial compression loading. The stringers and frames divided the panel into six bays with two columns of three bays each along the compressive loading direction. The two frames were supported at the ends with pins to restrict the out-...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Arabian Journal for Science and Engineering
سال: 2014
ISSN: 1319-8025,2191-4281
DOI: 10.1007/s13369-014-1411-1