منابع مشابه
MEMS Test Structures for Residual Stress Measurements
A set of microstructures for in situ stress measurement is presented, based on a lancet principle having dedicated designs for the amplification of dimensional variation induced by internal stress of the materials. The presented technique has an advantage over the traditional rotating structures and wafer curvature measurements in terms of the simplified readout mechanism. The test structures a...
متن کاملEffect of lattice mismatch on gate lag in high quality InAlN/AlN/GaN HFET structures
Grown lattice matched to GaN, InAlN-based heterojunction field effect transistors (HFETs) are promising due to the relatively large band discontinuity at the interface and lack of misfit strain. Despite the recent progress in the growth, there still exists some questions as to the true lattice matching condition of InAlN to GaN due to discrepancies in the value of the lattice parameters of the ...
متن کاملA New Approach to Buckling Analysis of Lattice Composite Structures
Buckling strength of composite latticed cylindrical shells is one of the important parameters for studying the failure of these structures. In this paper, new governing differential equations are derived for latticed cylindrical shells and their critical buckling axial loads. The nested structure under compressive axial buckling load was analyzed. Finite Element Method (FEM) was applied to mode...
متن کاملPlastic collapse of lattice structures under a general stress state
We present a numerical minimization procedure to determine the macroscopic ‘plastic collapse strength’ of a tessellated cellular structure under a general stress state. The method is illustrated with sample cellular structures of regular and hierarchical honeycombs. Based on the deformation modes found by minimization of plastic dissipation, closed-form expressions for strength are derived. The...
متن کاملOn-Chip Structures for Timing Measurements and Test
This paper describes the use of digitally set delay lines in conjunction with MUTEX time comparison circuits, to measure on-chip signal path timing differences to accuracies of better than 10ps. Three methods of time measurement are described. The first, which uses parallel MUTEXs with a tapped delay line, is analogous to a flash A/D converter. The second one is similar to a successive approxim...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: physica status solidi (a)
سال: 2010
ISSN: 1862-6300
DOI: 10.1002/pssa.200983556