Stress-Strain Relation of Plastic Deformation of Mild Steel along a Straight Strain Trajectory with Corner
نویسندگان
چکیده
منابع مشابه
The Strain Dependence of Post-Deformation Softening during the Hot Deformation of 304H Stainless Steel
Experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304H stainless steel. Three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the DRX critical strain: strongly strain dependent softening by SRX alone with softening kinetics control...
متن کاملStress-strain relations for crystals containing plastic deformation.
Let P be one of the possible slip planes in a crystal, and let X be one of the possible slip directions in the plane P. Also let S be the magnitude of the shearing stress on the plane P resolved in the direction X, and So the critical value of S, i.e., the least value of S sufficient to permit slip or plastic deformation under the conditions specified in the following italicized statement; if s...
متن کاملPREDICTION OF HOT DEFORMATION BEHAVIOUR OF A PH STAINLESS STEEL AT HIGH STRAIN RATES
In this study the hot deformation behaviour of a precipitation hardened (PH) stainless steel at high strain rates has been predicted through hot compression testing. Stress-strain curves were obtained for a range of strain rates from 10-3 to 10+1 S-1 and temperatures from 850 to 1150°C. Results obtained by microstructure and stress-strain curves show that at low temperatures and high strain rat...
متن کاملInvestigation of Stress-Strain Behavior of Plastic Concrete Using Monotonic Triaxial Compression Tests
In this paper, the mechanical behavior of plastic concrete being used in the cut-off walls of earth dams has been studied. To do the task, triaxial compression tests on the specimens in various ages and mix designs under different confining pressures have been done and the stress-strain behavior of such materials and their strength parameter changes has been experimentally investigated. It has ...
متن کاملA New Technique based on Strain Energy for Correction of Stress-strain Curve
Tensile stress-strain curve is of high importance in mechanics of materials particularly in numerical simulations of material deformations. The curve is usually obtained by experiment but is limited by necking phenomenon. Engineering stress-strain curve is converted to true stress-strain curve through simple formulas. The conversion, however, is correct up the point of necking. From this point ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1977
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.43.55