Stress-strain Relation of Brass for the Plastic Deformation along Bi-linear Strain Trajectories with Various Corner Angles
نویسندگان
چکیده
منابع مشابه
Stress-strain relations for crystals containing plastic deformation.
Let P be one of the possible slip planes in a crystal, and let X be one of the possible slip directions in the plane P. Also let S be the magnitude of the shearing stress on the plane P resolved in the direction X, and So the critical value of S, i.e., the least value of S sufficient to permit slip or plastic deformation under the conditions specified in the following italicized statement; if s...
متن کاملDeformation Behavior of a 70/30 Alpha Brass in Plane Stress/plane Strain
Generally a simple power law ~ = K E" (where K and n are empirical constants called the strength coefficient and the work hardening coefficient respectively) is used to describe plastic stress-strain dependence of deformable metals (1,2). This equation was employed by Low (3) to describe the uniaxial tensile behavior of an annealed 70/30 brass. The slope of the corresponding double logarithmic ...
متن کاملThe Strain Dependence of Post-Deformation Softening during the Hot Deformation of 304H Stainless Steel
Experiments were carried out in which the dependence of the fractional softening on temperature, time and strain rate was determined in a 304H stainless steel. Three prestrain ranges were identified pertaining to three different post-deformation softening behaviors: 1) prestraining to below the DRX critical strain: strongly strain dependent softening by SRX alone with softening kinetics control...
متن کاملA New Technique based on Strain Energy for Correction of Stress-strain Curve
Tensile stress-strain curve is of high importance in mechanics of materials particularly in numerical simulations of material deformations. The curve is usually obtained by experiment but is limited by necking phenomenon. Engineering stress-strain curve is converted to true stress-strain curve through simple formulas. The conversion, however, is correct up the point of necking. From this point ...
متن کاملCrystal plasticity analysis of constitutive behavior of 5754 aluminum sheet deformed along bi-linear strain paths
Sheet specimens of aluminum alloy 5754 were deformed along a series of bi-linear, equal-biaxial and uniaxial, strain paths while simultaneously measuring stress–strain behavior. The Visco-Plastic Self-Consistent crystal plasticity model, which incorporates texture evolution, was used to simulate the flow stress and hardening behavior based in part on the measured crystallographic texture before...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of JSME
سال: 1981
ISSN: 0021-3764,1881-1426
DOI: 10.1299/jsme1958.24.1909