Stress-Strain Relation in Cutting Metal with Two Different Crystal Grains
نویسندگان
چکیده
منابع مشابه
Comparison of Cutting Ceramics with Hard Metal Cutting Tools
Cutting ceramic tools are used especially at high cutting speeds in the machining process. The highly brittle type of structure and the tendency for cleavage (crack formation) are the infavorable properties of these materials, which keep their hardness at high temperatures. The hard metals are produced by sintering of the carbides such as whisker WC, TiC and TaC with the presence of Co as a bin...
متن کاملStress-Strain Behavior of Cementitious Materials with Different Sizes
The size dependence of flexural properties of cement mortar and concrete beams is investigated. Bazant's size effect law and modified size effect law by Kim and Eo give a very good fit to the flexural strength of both cement mortar and concrete. As observed in the test results, a strong size effect in flexural strength is found in cement mortar than in concrete. A modification has been suggeste...
متن کاملAn Algorithm for Two Dimensional Cutting Stock Problems with Demand
In this paper, two-dimensional cutting stock problem with demand has been studied.In this problem, cutting of large rectangular sheets into specific small pieces should be carried out hence, the waste will be minimized. Solving this problem is important to decrease waste materials in any industry that requires cutting of sheets. In most previus studies, the demand of pieces has not been usually...
متن کاملAn Algorithm for Two Dimensional Cutting Stock Problems with Demand
In this paper, two-dimensional cutting stock problem with demand has been studied.In this problem, cutting of large rectangular sheets into specific small pieces should be carried out hence, the waste will be minimized. Solving this problem is important to decrease waste materials in any industry that requires cutting of sheets. In most previus studies, the demand of pieces has not been usually...
متن کاملStress dip under a two-dimensional semipile of grains.
The origin of stress dip under the apex of a standard sandpile has stimulated significant debate within the scientific community. On the other hand, it could be argued that a semipile built against a vertical wall is of more practical interest since it serves as a model of dams, dykes, and embankments. There is surprisingly little information available for the stress distribution in this case. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C
سال: 1983
ISSN: 0387-5024,1884-8354
DOI: 10.1299/kikaic.49.1290