Stress Dependence of Strain Rate during Steady State Creep of Al-Zn Solid Solution Alloys
نویسندگان
چکیده
منابع مشابه
CREEP AGE FORMING OF Al-Zn-Mg ALLOYS WITH OPTIMIZATION OF MECHANICALl PROPERTIES
Creep age forming (CAF) is one of the novel methods in aerospace industry that has been used to manufacture components of panels with improved mechanical properties and reduced fabrication cost. CAF is a combined age-hardening and stress-relaxation that are responsible for strengthening and forming, respectively. This paper deals with the experimental investigations of mechanical and springback...
متن کاملMicrostructure of Al-Zn and Zn-Al Alloys*
The change of microstructure of the title alloys with concentration, temperature and applied thermal treatment was studied in situ by XRD. The alloys, having the Zn atomic fraction, x(Zn), from 0.03 to 0.62, were subjected to: (i) rapid quenching from a temperature, Tt, higher than the solid-solution temperature, Tss, in water at RT (samples WQ); (ii) slow cooling from Tt to RT (samples SC). Th...
متن کاملCreep Behavior of Al-Si Die-Cast Alloys
Commercial, aluminum die-cast alloys are subject to long-term stresses leading to viscoelastic material responses resulting in inefficient engine operation and failure. Constant load creep tests were conducted on aluminum die-casting alloys: B-390, eutectic Al-Si and a 17% Si-Al alloys. Rupture occurred in the primary creep regime, with the eutectic alloy having the longest times to failure. Pr...
متن کاملHistories of the Stress, Strain-rate, Temperature and Spin in Steady State Penetration Problems
Ah&act-Given the values of the two components of the velocity, temperature, hydrostatic pressure and work-hardening parameter at a large number of discrete points in a bounded 2-D domain, an algorithm has been developed to compute the streamline that passes through a desired point in the domain, and the time histories of the stress, strain-rate, temperature and the spin at a material particle, ...
متن کاملModeling Anisotropy and Steady State Creep in a Rotating Disc of Al-SiCp having Varying Thickness
The analysis of steady state creep in a rotating disc made of Al-SiCp composite having variable thickness has been carried using Sherby’s constitutive model. The creep parameters have been evaluated using the available experimental results in the literature using regression analysis. Three variations in the thickness (constant, linearly and hyperbolic varying thickness) of the disc have been co...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1971
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.35.5_427