Stress Concentration at Window Corners of Commuter-Car
نویسندگان
چکیده
منابع مشابه
Car side window kinematics
It is a demanding and time-consuming task to construct the side window mechanism of a car such that the deflections along the seals are minimized. The reason for this is that the window surface S delivered by the stylist, will in general not be movable in a proper way: It is required that the surface tightly moves along the seals. Deflections will necessarily occur no matter how much effort the...
متن کاملSingular stress fields at corners in flip-chip packages
An electronic device integrates diverse materials, and inevitably contains sharp features, such as interfaces and corners. When the device is subject to thermal and mechanical loads, the corners develop intense stress and are vulnerable sites to initiate failure. This paper analyzes stress fields at corners in flip-chip packages. The stress at a corner is a linear superposition of two modes of ...
متن کاملMotion blur estimation at corners
In this paper we propose a novel algorithm to estimate motion parameters from a single blurred image, exploiting geometrical relations between image intensities at pixels of a region that contains a corner. Corners are significant both for scene and motion understanding since they permit a univocal interpretation of motion parameters. Motion parameters are estimated locally in image regions, wi...
متن کاملEvaluation of Service-induced Residual Stresses in Railroad Commuter Car Wheels
Analyses of the effects of service conditions on the distribution of residual stresses in railroad commuter car wheels are presented. Novel software has been applied to estimate the effects of service conditions on the as-manufactured state of these wheels. Contact loads resulting from wheel and rail interaction and thermal loads from on-tread braking are considered. Results indicate that conta...
متن کاملDelamination of Compressed Thin Layers at Corners
An analysis of delamination for a thin elastic film, attached to a substrate a corner, is carried out. The film is in compression and the analysis is performed by combining results from fracture mechanics and the theory of thin shells. The results show a very strong dependency of the angle of the corner. In contrast with earlier results for delamination on a flat substrate, the present problem ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Japan Society of Mechanical Engineers
سال: 1970
ISSN: 0029-0270,2185-9485
DOI: 10.1299/kikai1938.36.1099