Stress-assisted atomic diffusion in metastable austenite D03 phase of Cu-Al-Be shape memory alloys
نویسندگان
چکیده
منابع مشابه
Magnetoelasticity and Magnetoresistance in Cu–Al–Mn Shape-Memory Alloys
This paper is aimed at studying the effect of a magnetic field on the martensitic transition of a Cu–Al–Mn shape-memory alloy. The martensitic transition has been studied through resistance measurements under applied magnetic fields ranging from 0 to 50 kOe. Negative magnetoresistance showing an almost linear dependence with the square of the magnetization has been observed. This magnetoresisti...
متن کاملAging behavior in Cu–Al–Be shape memory alloy
This article reports positron annihilation spectroscopy and calorimetric measurements of the aging behavior in a Cu–Al–Be shape memory alloy. An excess of single vacancies is retained in the alloy as a result of a quench. All vacancies in excess disappear after long aging time, and a migration energy EM51.060.1 eV for this process has been found to be larger than in other Cu-based shape memory ...
متن کاملShape Memory Effect in Diffusion Bonded Cu Base Shape Memory Alloys/Steel Interfaces
In many applications, Cu base Shape Memory Alloys (SMA S) are a more economical alternative to other systems showing Shape Memory Effect (SME). However, bearing in mind the potential use of these SMA it is becoming increasingly important to develop suitable techniques to join them satisfactorily to themselves and to another material. In that sense, a liquid phase diffusion bonding process with ...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملShape Memory Properties in Cu-Zn-Al Alloy
In this research a Cu-Zn-Al alloy is produced by melting the raw materials in an electric resistance furnace and then pouring it into a steel mould. The optimum way to achieve the final analysis in the hypo-eutectoid range is determined and the influence of the alloying element, Ti on the grain size and the shape memory properties of the samples are investigated. Solution treatment (done at 850...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Scripta Materialia
سال: 2016
ISSN: 1359-6462
DOI: 10.1016/j.scriptamat.2016.06.034