Strength Recovery Model of Clay during Thixotropy
نویسندگان
چکیده
منابع مشابه
Signs of muscle thixotropy during human ballistic wrist joint movements.
A study was conducted on healthy subjects to determine whether voluntary ballistic wrist flexion movements are influenced by immediately preceding conditioning of the forearm muscles. Single rapid wrist flexion movements were made in response to an auditory "Go" signal. Rectified surface EMG was recorded from wrist flexors and extensors, and joint position was measured by a goniometer. The move...
متن کاملStrength Recovery in a High-Strength Steel During Multiple Weld Thermal Simulations
BlastAlloy 160 (BA160) is a low-carbon martensitic steel strengthened by copper and M2C precipitates. Heat-affected zone (HAZ) microstructure evaluation of BA160 exhibited softening in samples subjected to the coarse-grained HAZ thermal simulations of this steel. This softening is partially attributed to dissolution of copper precipitates and metal carbides. After subjecting these coarse-graine...
متن کاملViscous Rate Effects in Shear Strength of Clay
Viscous rate effects are commonly observed in clay soils in applications that involve high strain rates such as free falling penetrometer tests. Viscous rate effects are not well studied thus affecting reliable interpretation of these applications. This paper presents an investigation of viscous rate effects in clay using laboratory rate studies covering a wide range of strain rates (6 orders o...
متن کاملEffect of Moisture Content on Shear Strength of Offshore Clay Interface Steel Surface
This paper investigates the effect of moisture content on interface shear strength between offshore clay and steel plate. Although, sensitive and high plasticity offshore clay deposits are widely distributed in Malaysia and many other countries in the world, and steel is a vital construction material for many structures, research works on interaction between offshore clay and steel surface are ...
متن کاملInvestigation on Tensile Strength of Friction Stir Welded Joints in PP/EPDM/Clay Nanocomposites
Polymer-based nanocomposites due to their advantages such as corrosion resistance,adequate mechanical properties and low cost are widely used in modern technologies. The increasing application of these nanocomposites, and hence their welding seems unavoidable. In this paper, a novel hottool in friction stir welding process is used for butt welding nanocomposite plates of 5 mm thick containing p...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Civil Engineering
سال: 2021
ISSN: 1687-8094,1687-8086
DOI: 10.1155/2021/8825107