STRENGTH EVALUATION OF WIDE FLANGE STEEL CONNECTIONS WITH TRANSVERSE STIFFENERS CONSIDERING LOCAL FLANGE BENDING
نویسندگان
چکیده
منابع مشابه
A Stress Analysis of Pipe Flange Connections
The use of pipe flange connections is standardized in the codes of JIS, ASME, DIN and so on. However, these codes are almost entirely dependent on experience, and subsequently some problems concerning pipe flange connections have been encountered. In the present paper, the distribution of contact stresses which governs the sealing performance is analyzed as a three-body contact problem, using a...
متن کاملInfluence of cold bending on the resistance of wide flange members
Cold roller bending is commonly used for bending straight members with hot rolled wide-flange sections to create arches. This process induces plastic deformations along the member, so that it can acquire the desired curvature. The resulting residual stress distribution is different from the wellknown residual stress pattern due to hot rolling. Extensive studies have shown that the influence of ...
متن کاملRehabilitating mandibular resection with guide flange prosthesis.
Loss of continuity of the mandible leads to deviation of the residual segment towards the surgical site and alteration in muscle function. This results in facial asymmetry and malocclusion. A corrective device known as 'guide flange prosthesis' is indicated to limit this clinical manifestation. Guide flange prosthesis serves as a training device. It can successfully guide the patient to close t...
متن کاملSpeech intelligibility with the buccal flange obturator.
habilitation of patients who have undergone extensive surgery for eradication of neoplasm of the maxillae requires restoration of the functions of speech, mastication, and deglutition. The options for rehabilitation of these patients are surgical reconstruction or prosthetic restoration. According to Sharry,’ even when surgical techniques are available, prosthetic reconstruction is chosen most ...
متن کاملFatigue Strength of Fillet-Welded Transverse Stiffeners with Undercuts
Presently, wrapping of the welds at the ends of stiffeners is not done to avoid the undercutting of the stiffener corners and the attendant weld repair. The fatigue performance of stiffeners with undercuts was evaluated in a factorial design fatigue experiment. Undercuts at the flange edge and filling of the stiffener cope with the fillet weld were also evaluated. The undercuts did not influenc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Structural and Construction Engineering (Transactions of AIJ)
سال: 2007
ISSN: 1340-4202,1881-8153
DOI: 10.3130/aijs.72.157_3