Strength Evaluation for Wire of Semiconductor Package.
نویسندگان
چکیده
منابع مشابه
OF PACKAGE I / O LEAD ELECTRICAL PARASITICS FOR DIFFERENT PACKAGES Electrical Parameters Wire - bonding Package Type
This paper is concerned with the analysis and optimization of the ground bounce in digital CMOS circuits. First, an analytical method for calculating the ground bounce is presented. The proposed method relies on accurate models of the short-channel MOS device and the chip-package interface parasitics. Next the effect of ground bounce on the propagation delay and the optimum tapering factor of a...
متن کاملRebond strength of bonded lingual wire retainers.
There is no consensus in the literature concerning the rebonding procedure for orthodontic retainers. The aim of this in vitro study was to evaluate the bond and rebond strength of retainers bonded to enamel surfaces with and without composite remnants. The retainers were bonded with Excite and Tetric Flow on three different surfaces: clean enamel, enamel where the composite had been removed by...
متن کاملPlasmon-pole approximation for semiconductor quantum-wire electrons.
We develop the plasmon-pole approximation for an interacting electron gas confined in a semiconductor quantum wire. We argue that the plasmon-pole approximation becomes a more accurate approach in quantum wire systems than in higher dimensional systems because of severe phase-space restrictions on particle-hole excitations in one dimension. As examples, we use the plasmon-pole approximation to ...
متن کاملDesign and Evaluation of e-Learning Package for Breast Cancer Prevention for Iranian Women
Introduction: Given the high prevalence of breast cancer and its incidence and mortality worldwide, it seems that prevention is the best way to control it. The challenge facing e-learning is the production of appropriate, usable, and effective content. In this study, an electronic educational package titled “Breast Cancer Prevention” was designed and evaluated. Methods: This research was condu...
متن کاملEvaluation of Thin Copper Wire and Lead-Free Solder Joint Strength by Pullout Tests and Wire Surface Observation
Copper wires have been attracting much attention for Large Scale Integration (LSI) bonding because of their excellent mechanical and electrical properties, in addition to their low material cost. The ends of these wires are usually joined to pads or through-holes on a printed circuit board, and lead-free soldering is one of the popular bonding methods. Since the deformation resistance of solder...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Japan Institute of Electronics Packaging
سال: 1998
ISSN: 1343-9677,1884-121X
DOI: 10.5104/jiep.1.221