Strength criterion for rocks subjected to cyclic stress and temperature variations
نویسندگان
چکیده
منابع مشابه
Proposals for a Failure Criterion Applicable to Discontinuous Rocks
The existing failure criteria to evaluate discontinuous rocks are predominatly based on the relations between principal stresses at failure. None of the criteria has a direct reference to the magnitude of deformation as a major parameter in rock Several reasons are identified indicating that the selection of peak stress as a major parameter, which is obtained through the evaluation of a failure...
متن کاملCongenital heart defects in chick embryos subjected to temperature variations.
• Several epidemiological studies" have shown a positive correlation between viral diseases early in pregnancy and congenital heart disease in human beings. Since viral diseases are accompanied commonly by fever, it was considered important to investigate the effect of high temperature alone on the development of the heart in chick embryos. It was also thought that incubation at low temperature...
متن کاملConcrete Filled Tubular Bracing Subjected to Cyclic Loading
The energy absorption of concrete filled, hollow-steel bracing was analyzed respect to geometric and mechanical parameters including the width-to-thickness section ratio, slenderness level, and strength of the steel and concrete. Local buckling and ductility were also investigated with respect to variation in the cross-section. The infill increased the compression resistance, even after multipl...
متن کاملDrinking water temperature effects on laying hens subjected to warm cyclic environments.
Two experiments were conducted to evaluate the effects of drinking water temperature (Tw) on laying hens subjected to warm cyclic air temperature (Ta) conditions. Each experiment consisted of a 1-wk acclimation under thermoneutrality (TN) (Ta = Tw = 21 C), a 4-wk heat exposure or treatment period, and a 2-wk recovery under TN. Each experiment involved 24 individually caged hens at the initial a...
متن کاملMoisture Content - Strength Relationship for Lumber Subjected to Bending *
Kennedy (1965) reported small clear strength values for most Canadian species. The average value for modulus of rupture for Douglas Fir based upon 1057 specimens was reported to be 7540 p. s. (52 026 kN/m2 ) when tested in the green (wet) condition while the average value for air-dried specimens adjusted to 12% moisture content was found to be 12,850 p.s.i. (88 665 kN/m2 ), an increase of 71%. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Geophysics and Engineering
سال: 2015
ISSN: 1742-2132,1742-2140
DOI: 10.1088/1742-2132/12/5/753