Strength and Toughness of a Cold Rolled 13Ni-15Co-10Mo Maraging Steel
نویسندگان
چکیده
منابع مشابه
A New Maraging Stainless Steel with Excellent Strength–Toughness–Corrosion Synergy
A new maraging stainless steel with superior strength-toughness-corrosion synergy has been developed based on an innovative concept of alloy design. The high strength-toughness combination is achieved by forming dispersive nano-sized intermetallic compounds in the soft lath martensitic matrix with a slight amount of residual austenite. The good corrosion resistance is guaranteed by exactly cont...
متن کاملStrength and Toughness of Reinforced Concrete with Coated Steel Fibers
The effect of zinc phosphate (ZP) and zinc calcium phosphate (ZCP) coatings on the reinforcing mechanisms of smooth steel fiber in cementitious matrix have been studied. The results of pull out tests illustrated that by coating smooth steel fiber the pull-out load may be increased up to 100%. The effect of zinc phosphate coating on interface bonding was more than zinc-calcium phosphate coating....
متن کاملFatigue strength evaluation of self-piercing riveted cold rolled steel joints under mixed mode loading conditions
Fatigue strength of cross-shaped specimens of SPR joints made of SPCC was evaluated at load angles of 0°, 45°, and 90°. For the static strength at load angles of 0°, 45°, and 90°, the maximum loads were determined to be 4890N, 1969N, and 1611N, respectively. Regarding for the relationship between the load amplitude and the number of cycles (Nf), the results were 014 . 0 3 . 2209 − = f amp N P ,...
متن کاملMechanical Property Determination of Heavy Steel Plates and Cold Rolled Steel Sheets by Micro-magnetic Ndt
The presentation is to results recently obtained in collaborative research in the European steel programme performed by Fraunhofer-IZFP and co-operative steel industry producing rolling products. The objective was and is to characterize i.e. to predict mechanical properties like hardness, yield strength, tensile strength, deep drawing parameters rm and ∆r, etc., mainly online by use of contact-...
متن کاملGrain Refinement of Dual Phase Steel via Tempering of Cold-Rolled Martensite
A microstructure consisting of ultrafine grained (UFG) ferrite with average grain size of ~ 0.7 µm and dispersed nano-sized carbides was produced by cold-rolling and tempering of the martensite starting microstructure in a low carbon steel. Subsequently, fine grained dual phase (DP) steel consisting of equiaxed ferrite grains with average size of ~ 5 µm and martensite islands with average size ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Transactions of the Iron and Steel Institute of Japan
سال: 1981
ISSN: 0021-1583,1881-1183
DOI: 10.2355/isijinternational1966.21.422