Str_??_cture Formation during the Melt-spinning Process
نویسندگان
چکیده
منابع مشابه
Striation Formation and Melt Removal in the Laser Cutting Process
Introduction The formatIOn of periodIC patterns (stnatlOn) has drawn much attentIon In contInUOUS wave laser cutt time (s) tp time penod per oxidation cycle (s) U gas velOCIty profile (m/s) Uo streamwlse gas velOCIty (m/s) V Interfacial velOCIty (m/s) u lIqUId velOCIty In x dIrectIOn (m/s) v hqUId velOCIty In y dIrectIOn or cuttIng speed (m1s) v. fnctIon velOCIty (m/s) W actIvatIOn energy (J) W...
متن کاملOptimal Control of Melt Spinning Processes
An optimal control problem for a mathematical model of a melt spinning process is considered. Newtonian and non–Newtonian models are used to describe the rheology of the polymeric material, the fiber is made of. The extrusion velocity of the polymer at the spinneret as well as the velocity and temperature of the quench air serve as control variables. A constrained optimization problem is derive...
متن کاملmatrix-fibril morphology and structure of polyblend fibers in melt spinning process: a review
the mechanism and the parameters affecting the matrix-fibril morphology in melt spun polyblend fibers are discussed. the properties of polymeric blends depend considerably on their final morphologies. blending of two miscible polymers, normally gives rise to formation of a single-phase morphology while blending of two immiscible polymers can create a two or three (in case of using compatibilize...
متن کاملconsequence analysis of the leakage, ignition and explosion during high pressure sour gas injection process to the oil reservoir
there is no doubt that human being needs to become integrated with industry and industry needs to be progressed, daily. on the other hand, serious events in industrial units specially in oil industries has been shown that such damages and events are industry related ones. the consequence of such events and damages which resulted in chemical and poisoned explosions and loss of life and property ...
Heat Transfer during Melt Spinning of Al-7%si Alloy on a Cu-be Wheel
Transient heat transfer models of the single-wheel meltspinning process are developed and applied to quantify the effect of process variables including interface depressions on solidification, temperature evolution, thickness variations, and surface depressions in the cast product. Firstly, a transient one-dimensional heat-transfer model of the melt-spinning process called STRIP1D was developed...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sen'i Gakkaishi
سال: 1967
ISSN: 0037-9875,1884-2259
DOI: 10.2115/fiber.23.s300