Stored Energy and Taylor Factor Relation in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending
نویسندگان
چکیده
منابع مشابه
Stored Energy and Taylor Factor Relation in an Al-Mg-Mn Alloy Sheet Worked by Continuous Cyclic Bending
The relation between the stored energy and the Taylor factor (TF) has been investigated using the SEM/EBSP analysis in an Al-Mg-Mn alloy sheet worked by the continuous cyclic bending (CCB). The analysis reveals that the stored energy is high for the high TF region, whereas a significant increase of the stored energy with the decrease of the Taylor factor appears in the vicinity of the minimum T...
متن کاملDsc Study of Precipitation in an Al-mg-mn Alloy Microalloyed with Cu
Power compensation DSC has been employed to detect and analyse precipitation reactions in an Al1.3Mg-0.4Mn and an Al-1.3Mg-0.4Mn-0.07Cu alloy in which very small amounts of precipitate, less than 0.3 at%, are expected to form. Due to the very small heat effects, baseline instability and drift significantly interfere with the measurements. After repeated experiments and careful baseline correcti...
متن کاملFRACTIONAL RECRYSTALLIZATION KINETICS IN DIRECTLY COLD ROLLED Al-Mg, Al-Mg-Sc AND Al-Mg-Sc-Zr ALLOY
The evaluation of texture as a function of recrystallization has been characterized for directly cold rolled Al-6Mg, Al-6Mg-0.4Sc and Al-6Mg-0.4Sc-0.2Zr alloys. Samples were annealed isothermally at 400 °C for 1 to 240 minutes to allow recrystallization. Recrystallization kinetics of the alloys is analyzed from the micro-hardness variation. Isothermally annealed samples of aluminum alloys were ...
متن کاملCrystallographic Orientation Distribution Control by Means of Continuous Cyclic Bending in a Pure Aluminum Sheet
Continuous cyclic bending (CCB) has been proposed as a useful straining technique to produce the high strain on the surface layers and the lower strain in the central layer of the sheet. A pure aluminum sheet is worked by the CCB using the ‘‘Roll traveling device’’ and ‘‘Roll driven machine’’. It is found that a sharp Cube orientation is formed by the CCB and subsequent annealing in the pure al...
متن کاملComparison of Mechanical Behavior and Microstructure of Continuous Cast and Hot Worked CuZn40Al1 Alloy (TECHNICAL NOTE)
The performance of components produced by conventional route of a thermo mechanical process and those produced by continuous casting is interesting from different aspects of economy and technology. The performance of products in their service depends on their properties which are strongly influenced by production routes. In the present work the hardness, tensile and tensile-impact behaviors of ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2004
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.45.2316