Stoichiometry Splitting of β Phase in Ni-Al-Mn, Ni-Al-Co and Ni-Al-Fe Ternary Systems
نویسندگان
چکیده
منابع مشابه
CALCULATION OF THERMODYNAMIC PROPERTIES OF Al-Fe, Al-Ni AND Ni-Fe ALLOYS USING FACTSAGE
Thermodynamic predicting analysis of three binary systems Al-Fe, Al-Ni and Ni-Fe are shown in this paper. Thermodynamic analysis involved calculation of activities, coefficient of activities, partial and integral values for enthalpies and Gibbs energies of mixing and excess energies at three different temperatures: 1873K, 1900K and 1973K, as well as calculated phase diagrams, for the investigat...
متن کاملCreep of Ni-Al and Ni-Cr-Al Superalloy Foams
The steady-state creep rate of Ni-base metallic foams, with superalloy composition (in wt. pct) Ni7.8∼9.1Al (relative density, ρ = 2.5-2.6) and Ni-13.5∼16.6Cr-5.1∼8.9Al (ρ = 2.8∼3.0), was measured under a range of temperatures (680∼825°C) and applied stresses (0.1∼0.3 MPa), and compared with that of NiAl intermetallic foams (ρ = 5.3). The stress exponent and activation energy are within the exp...
متن کاملOrdered oxide layers on decagonal Al-Co-Ni and icosahedral Al-Pd-Mn quasicrystals
Metal oxides display a variety of crystal structures which often are more complicated compared to the parent metals [1]. In particular, the oxide structures grown on ordered aluminum binary alloys have been an immense challenge for scientists since decades [2]. On NiAl(110), oxygen binds to Al and forms an atomically thin layer of super-cell epitaxy with a huge unit cell. We investigate the str...
متن کاملReaction of Al/Ni Multilayers
Sputtered reactive multilayers applied as a heat source in electronic joining processes are 11 an emerging technology. It promises low-stress assembly of components while improving the 12 thermal contact and thus thermal resistance. The use of nanostructures can significantly enhance 13 the adhesion and reliability of joints between different materials. This work presents a 14 phenomenological ...
متن کاملSynthesis, structure, and mechanical properties of Ni–Al and Ni–Cr–Al superalloy foams
Reticulated nickel foams were alloyed with 8–9 wt% Al or 14–18 wt% Cr and 5–9 wt% Al in a three-step method consisting of (i) gas-phase deposition of Cr and/or Al onto the struts of a pure Ni foam by pack-cementation at 1000 C; (ii) homogenization at 1200 C to remove concentration gradients and to solutionize the alloyed struts; (iii) aging at 900 C to form c0 precipitates within the struts. Th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: MATERIALS TRANSACTIONS
سال: 2001
ISSN: 1345-9678,1347-5320
DOI: 10.2320/matertrans.42.464