Stereolithography-based 3D printing of micro-channels for vascularized hydrogels
نویسندگان
چکیده
منابع مشابه
Synthesis of biodegradable photocrosslinkable polymers for stereolithography-based 3D fabrication of tissue engineering scaffolds and hydrogels
Aalto University, P.O. Box 11000, FI-00076 Aalto www.aalto.fi Author Laura Elomaa Name of the doctoral dissertation Synthesis of biodegradable photocrosslinkable polymers for stereolithography-based 3D fabrication of tissue engineering scaffolds and hydrogels Publisher School of Chemical Technology Unit Department of Biotechnology and Chemical Technology Series Aalto University publication seri...
متن کاملBiofunctional Photopolymers for Micro-Stereolithography
Vienna University of Technology, Institute of Applied Synthetic Chemistry, Getreidemarkt 9/163-MC, A-1060 Vienna, Austria E-mail: [email protected] ** Ludwig Boltzmann Institute of Osteology at the Hanusch Hospital of WGKK and AUVA Trauma Centre Meidling.4 Medical Department , Heinrich Collin-Strasse 30, A-1140 Vienna, Austria *** Vienna University of Technology, Institute of Mat...
متن کاملOptimising low molecular weight hydrogels for automated 3D printing.
Hydrogels prepared from low molecular weight gelators (LMWGs) are formed as a result of hierarchical intermolecular interactions between gelators to form fibres, and then further interactions between the self-assembled fibres via physical entanglements, as well as potential branching points. These interactions can allow hydrogels to recover quickly after a high shear rate has been applied. Ther...
متن کامل3D Printing: 3D Printing of Highly Stretchable and Tough Hydrogels into Complex, Cellularized Structures.
X. Zhao and co-workers develop on page 4035 a new biocompatible hydrogel system that is extremely tough and stretchable and can be 3D printed into complex structures, such as the multilayer mesh shown. Cells encapsulated in the tough and printable hydrogel maintain high viability. 3D-printed structures of the tough hydrogel can sustain high mechanical loads and deformations.
متن کاملSelf-assembled micro-organogels for 3D printing silicone structures
The widespread prevalence of commercial products made from microgels illustrates the immense practical value of harnessing the jamming transition; there are countless ways to use soft, solid materials that fluidize and become solid again with small variations in applied stress. The traditional routes of microgel synthesis produce materials that predominantly swell in aqueous solvents or, less o...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Frontiers in Bioengineering and Biotechnology
سال: 2016
ISSN: 2296-4185
DOI: 10.3389/conf.fbioe.2016.01.01303