Steelmaking-Casting of Molten Steel by Decarburization Ladle Matching
نویسندگان
چکیده
منابع مشابه
Steelmaking and Casting
Thin slab casting and rolling was originally developed as a low cost alternative to a conventional casting and rolling process route. However, due to the technological restrictions of the first generation plants, only limited quality and productivity goals could be achieved, questioning its further application to more advanced applications. This paper describes the original contributions that D...
متن کاملModeling of Gas flows in Steelmaking Decarburization Processes
............................................................................................................................. v Acknowledgements ......................................................................................................... vii Supplements...................................................................................................................... xi
متن کاملMolten Steel Level Control of Strip Casting Process Monitoring by Using Self-Learning Fuzzy Controller
The twin-roll strip casting process is a typical steel-strip production method which combines continuous casting and hot rolling process. The production line from molten liquid steel to the final steel-strip is shortened and the production cost is reduced significantly compared to the conventional continuous casting. The twin-roll strip casting process can produce 1-5 mm thin steel strip direct...
متن کاملMeasurement of Decarburization of Heat Treated Steel Surfaces
Decarburization is a significant problem in the heat treatment of steels as decarburization is detrimental to wear life and fatigue life of components. This presentation concentrates on its measurement by four procedures. Test results from an interlaboratory test of steels with spheroidize annealed, lamellar pearlite (normalized) and quenched and tempered martensitic microstructures were evalua...
متن کاملAlgorithm for Prevention of Molten Steel Sticking onto Mold in Continous Casting Process
Major loss in terms of time and money in modern steel production are due to inefficient execution of the continuous casting process. The lack of monitoring and control by means of computer systems, over manual execution, for example, i.e. the inefficient continuous casting process operation, may often cause delays in workflow performance, raise the percentage of scrap material and, in extreme c...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mathematical Problems in Engineering
سال: 2018
ISSN: 1024-123X,1563-5147
DOI: 10.1155/2018/7567591