Steam boilers and engines for high pressures
نویسندگان
چکیده
منابع مشابه
High-pressure Steam Engines and Computer Software the Problems of Exploding Boilers
The introduction of computers into the control of potentially dangerous devices has led to a growing awareness of the possible contribution of software to serious accidents The number of computer related accidents so far has been small due to the restraint that has been shown in introducing them into safety critical control loops However as the economic and technological bene ts of using comput...
متن کاملBasic Water Treatment of Steam Boilers
In order to fully understand what a given boiler needs for treatment, a basic study of its supply water must be done first. Three types of impurities exist in all supplies and can cause a wide range of problems in boilers and kilns. These impurities are suspended solids, dissolved solids, and dissolved gasses. Water picks up the impurities from the ground it contacts and the air through which i...
متن کاملEconomical optimization of steam data for recovery boilers
Pulp and paper mills are high power consuming industries. Pulp and integrated mills produce power via steam turbines in recovery boilers. Due to high power prices and the fact that biomass combusted in the recovery boiler is considered as green energy, there is today a desire to always increase the power generation when investing in new recovery boilers. In order to increase power output from t...
متن کاملProtection from steam at high pressures: development of a test device and protocol.
Extensive use of pressurized steam in the oil and gas sectors has led to incidents where workers were seriously injured. In this study a test device and procedure to measure heat transfer through fabrics during steam exposure were developed and evaluated. Several factors were considered while designing the test device to simulate work site conditions. Fabrics were exposed to steam at 2 distance...
متن کاملDifferences between Steam-water and Air-water Capillary Pressures
Steam-water flow exists in most geothermal reservoirs where steam-water capillary pressure plays an important role in controlling fluid distribution, transfer of liquid between fracture and matrix, well productivity, and even the reserves. However, it is very difficult to measure steam-water capillary pressure due to the phase transformation and the significant mass transfer between the two pha...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Franklin Institute
سال: 1877
ISSN: 0016-0032
DOI: 10.1016/0016-0032(77)90474-4