Steady-state motion of a mode-III crack on imperfect interfaces
نویسندگان
چکیده
منابع مشابه
Steady-state mode III cracks in a viscoelastic lattice model
We extend the Slepyan solution of the problem of a steady-state crack in an infinite ideally brittle lattice model to include dissipation in the form of Kelvin viscosity. As a demonstration of this technique, based on the Wiener-Hopf method, we apply the method to mode III cracks in a square lattice. We use this solution to find the critical velocity at which the steady-state solution becomes i...
متن کاملSteady-State Motion Visual Evoked Potentials Produced by Oscillating Newton's Rings: Implications for Brain-Computer Interfaces
In this study, we utilize a special visual stimulation protocol, called motion reversal, to present a novel steady-state motion visual evoked potential (SSMVEP)-based BCI paradigm that relied on human perception of motions oscillated in two opposite directions. Four Newton's rings with the oscillating expansion and contraction motions served as visual stimulators to elicit subjects' SSMVEPs. An...
متن کاملSteady-state modeling of a turbocharger in gasoline engines
The gas flow estimation is crucial for the proper operation and monitoring of turbocharged (TC) engines with a torque structured engine control unit (ECU). This paper presents mean value models developed for modeling gas flow over the compressor, the turbine and the wastegate (WG) in a TC gasoline engine not equipped with a hot film air-mass flow meter (HFM). The turbine flow ...
متن کاملSteady-state mode I cracks in a viscoelastic triangular lattice
We continue our study of the exact solutions for steady-state cracks in ideally brittle viscoelastic lattice models by focusing on mode I in a triangular system. The issues we address include the crack velocity versus driving curve as well as the onset of additional bond-breaking, signaling the emergence of complex spatio-temporal behavior. Somewhat surprisingly, the critical velocity for this ...
متن کاملThe effect of crack surface interaction on the stress intensity factor in Mode III crack growth in round shafts
Turbine-generator shafts are often subjected to a complex transient torsional loading. Such transient torques may initiate and propagate a circumferential crack in the shafts. Mode III crack growth in turbo-generator shafts often results in a fracture surface morphology resembling a factory roof. The interaction of the mutual fracture surfaces results in a pressure and a frictional stress field...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: The Quarterly Journal of Mechanics and Applied Mathematics
سال: 2006
ISSN: 0033-5614,1464-3855
DOI: 10.1093/qjmam/hbl013