منابع مشابه
An octane-fueled solid oxide fuel cell.
There are substantial barriers to the introduction of hydrogen fuel cells for transportation, including the high cost of fuel-cell systems, the current lack of a hydrogen infrastructure, and the relatively low fuel efficiency when using hydrogen produced from hydrocarbons. Here, we describe a solid oxide fuel cell that combines a catalyst layer with a conventional anode, allowing internal refor...
متن کاملIntegrating Multiple Solid Oxide Fuel Cell Modules
Abstract-According to SECA program guidelines, solid oxide fuel cells (SOFC) will be produced in the form of 3–10 kW modules for residential use. In addition to residential use, these modules can also be used in apartment buildings, hospitals, etc., where a higher power rating would be required. For example, a hospital might require a 250 kW power supply. To provide this power using the SOFC mo...
متن کاملElectrophoretic deposition of MnCr2O4 coating for solid oxide fuel cell metallic interconnects
In the present study, Mn - Cr spinel powder was synthesized through a solid state reaction. In the next step, the electrophoretic deposition (EPD) method was used to apply the MnCr2O4 spinel, as an oxidation-resistant layer, on SUS 430 stainless steel in a potential of 300 V/cm. The coated and uncoated samples were then pre-sintered in air at 900 °C for 3 h followed by cyclic oxidation at 800 °...
متن کاملEvaluation of solid oxide fuel cell anode based on active triple phase boundary length and tortuosity
An efficient procedure is presented for the evaluation of solid oxide fuel cell (SOFC) anode microstructure triple phase boundary length (TPBL). Triple phase boundary- the one that is common between three phases of the microstructure- has a great influence on the overall efficiency of SOFC because all electrochemical reactions of anode take place in its vicinity. Therefore, evaluation of TP...
متن کاملDevelopment of Copper-Ferrite Spinel Coating on AISI 430 Steel Used as Solid Oxide Fuel Cell
The bare and pre-oxidized AISI 430 pieces were screen printed by copper ferrite spinel coatings. Good bonding between the coating and the substrate was achieved by the reactive sintering process of the reduced coating. The energy dispersive X-ray spectroscopy (EDS) analysis revealed that the scale is a double layer consisting of a chromia-rich subscale and an outer Cu/Fe-rich spinel. The result...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 1999
ISSN: 0161-6374,2576-1579
DOI: 10.1149/199919.0028pv