Stationarity of I-mode operation and I-mode divertor heat fluxes on the ASDEX Upgrade tokamak

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

The Effect of Inclined U-Notch Geometry on Mode Ratio (KII/KI) under Mixed Mode (I + II) Loading

In inclined U-notches, the mixed mode (I + II) loading occurs and the mode ratio can be increased by varying the notch angle. In this paper, the effect of the inclined U-notch geometry, i.e. the notch depth, the notch angle, the notch root radius, and the position of the notch with respect to supports, on the mode ratio (KII/KI) have been studied. Three-point bending and plane strain condition ...

متن کامل

Dissipative Divertor Operation in the Alcator C-mod Tokamak Dissipative Divertor Operation in the Alcator C-mod Tokamak

The achievement of large volumetric power losses (dissipation) in the Alcator C-Mod divertor region is demonstrated in two operational modes: radiative divertor and detached divertor. During radiative divertor operation, the fraction of SOL power lost by radiation is P R/PSOL0.8 with single null plasmas, n e < 2x10 20 m-3 and I < 1 MA. These plasmas sometimes have very high recycling, with nedi...

متن کامل

Heat-flux footprints for I-mode and EDA H-mode plasmas on Alcator C-Mod

IR thermography is used to measure the heat flux footprints on C-Mod’s outer target in Imode and EDA H-mode plasmas. The footprint profiles are fit to a function with a simple physical interpretation. The fit parameter that is sensitive to the power decay length into the SOL, λSOL, is ~1-3x larger in I-modes than in H-modes at similar plasma current, which is the dominant dependence for the H-m...

متن کامل

Induced tungsten melting events in the divertor of ASDEX Upgrade and their influence on plasma performance

Tungsten rods of 1×1×3mm were exposed at the outer divertor plate of ASDEX Upgrade using a manipulator system. Controlled melting of the W rod in H-mode discharges was induced by moving the outer strike point towards the W-rod position. Visible light emission of ejected W droplets was recorded by fast camera systems. The resulting increase of tungsten concentration in the confined plasma was co...

متن کامل

Global electromagnetic simulations of the outer core of an ASDEX Upgrade L-mode plasma

The outer core of a low confinement discharge performed at the ASDEX Upgrade tokamak is investigated using both global and local nonlinear gyrokinetic simulations. Previous work [D. Told et al., Phys. Plasmas 20, 122312 (2013)] had shown that local gyrokinetic simulations agree reasonably well with experimental results in terms of transport levels, with minor discrepancies that can be resolved ...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Nuclear Materials and Energy

سال: 2019

ISSN: 2352-1791

DOI: 10.1016/j.nme.2018.12.022