Starting Pulse Rate of a Flat Type Linear Pulse Motor Driven by Constant Current
نویسندگان
چکیده
منابع مشابه
A Novel 36-pulse rectifier with low kVA rate to reduce harmonic input current distortion
The increase in the number of pulses in multipulse rectifiers leads to a reduction in harmonic current distortion. But this increase in the number of pulses leads to an increase in kVA, cost, and complexity of the multi-pulse rectifiers. As a result, in industrial applications, 12-pulse rectifiers are mainly used due to their lightweight, simple transformers, and low kVA rate, and low cost. The...
متن کاملInter-pulse Interval Affects the Size of Single-pulse TMS-induced Motor Evoked Potentials: a Reliability Study
Introduction: Measuring the size of motor evoked potentials (MEPs) induced by transcranial magnetic stimulation (TMS) is an investigational technique to show the level of corticospinal excitability however, some of the fundamental methodological aspects of TMS (such as the effects of inter-pulse intervals (IPI) on MEP size) are not fully understood, this issue raises concerns about the re...
متن کاملZinc-Nickel Binary Alloys Electrodeposition of Steel Using Pulse Current
Zinc-Nickel electrodeposits have been widely adopted for surface treatment of automobile steel sheet for high corrosion resistance. In this work the effect of pulse parameters on the Zn-Ni alloy electrodeposits was investigated. The hardness, thickness, corrosion resistance and composition of deposits thus produced were investigated. The surface topography of the deposits was also observed in S...
متن کاملZinc-Nickel Binary Alloys Electrodeposition of Steel Using Pulse Current
Zinc-Nickel electrodeposits have been widely adopted for surface treatment of automobile steel sheet for high corrosion resistance. In this work the effect of pulse parameters on the Zn-Ni alloy electrodeposits was investigated. The hardness, thickness, corrosion resistance and composition of deposits thus produced were investigated. The surface topography of the deposits was also observed in S...
متن کاملPulse-by-pulse Energy Measurement at the Stanford Linear Collider*
The Stanford Linear Collider (SLC) collides a beam of electrons and positrons at 92 GeV. It is the first colliding linac, and produces Zo particles for High-Energy Physics measurements. The energy of each beam must be measured to one part in lo4 on every collision (120 Hz). An Energy Spectrometer in each beam line after collision produces two stripes of highenergy synchrotron radiation with cri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEJ Transactions on Power and Energy
سال: 1983
ISSN: 0385-4213,1348-8147
DOI: 10.1541/ieejpes1972.103.374