Stainless steel channel sections under combined compression and minor axis bending – Part 2: Parametric studies and design
نویسندگان
چکیده
منابع مشابه
Combined Plastic Bending and Compression or Tension
So far we have assumed that a plastic hinge forms if the bending moment in a critical cross section reaches the plastic limit value, M0. We have tacitly neglected the effect of the other internal forces on the formation of the yield hinge. This effect, however, can be appreciable, for example in multi-storey frames or frames with a large horizontal thrust where the axial forces are large. So, w...
متن کاملDeformation Characteristic and Constitutive Modeling of 2707 Hyper Duplex Stainless Steel under Hot Compression
Hot deformation behavior and microstructure evolution of 2707 hyper duplex stainless steel (HDSS) were investigated through hot compression tests in the temperature range of 900–1250 ◦C and strain rate range of 0.01–10 s−1. The results showed that the flow behavior strongly depended on strain rate and temperature, and flow stress increased with increasing strain rate and decreasing temperature....
متن کاملBending Fatigue Tests and Finite Element Models of Steel Rectangular Hollow Sections [SRHS]
The Welding in cold formed areas is not only an open question for statically loaded sections (brittle fracture) but also for dynamically loaded structures (fatigue resistance). A lot of structures are subjected to dynamic loadings and unfortunately very little information about the influence of welding in the cold formed areas on fatigue resistance is available. In order to establish the fatigu...
متن کاملpostnatal studies of bats (pipistrellus kuhlii and miniopterus schreibersii) & histomorphology and histochemistry studies of organs and diseases of (neurergus microspilotus and n. kaiseri)
1. to determine whether difference in birth body mass influenced growth performance in pipistrellus kuhlii we studied a total of 12 captive-born neonates. bats were assigned to two body mass groups: light birth body mass (lbw: 0.89 ± 0.05, n=8) and heavy birth body mass (hbw: 1.35 ± 0.08, n=4). heavier body mass at birth was associated with rapid postnatal growth (body mass and forearm length) ...
European Regulation and Stainless Steel
Directives are addressed to the Governments of the Member States (MS). They stipulate the results to be achieved and the deadline(s), but leave the form of the legislation and the methods to be decided by each of the MS. Regulations are directly applicable and binding in all MS on the date of publication in the Official Journal. There are also Council or Commission Decisions that apply specific...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Constructional Steel Research
سال: 2019
ISSN: 0143-974X
DOI: 10.1016/j.jcsr.2018.03.028