Stacking-Fault Energy Measurements in Fe-Mn-Al-Si Austenitic TWIP Steels
نویسندگان
چکیده
منابع مشابه
Plastic strain due to twinning in austenitic TWIP steels
Twinning induced plasticity steels are austenitic alloys in which mechanical twinning is a prominent deformation mode, and which exhibit exceptional combinations of ductility, work hardening and ultimate strength. The authors develop in the present paper a crystallographic theory to enable the quantitative investigation of the role of mechanical twinning in enhancing the properties of these all...
متن کاملStacking Fault Energy and Microstructural Insight into the Dynamic Deformation of High-Manganese TRIP and TWIP Steels
The dynamic behavior of three high manganese steels with very different stacking faultenergy (SFE) values (4-30 mJ/m2) were studied using high strain rate torsional tests. The hotrolledmicrostructure of the steel with the lowest SFE of 4 mJ/m2 consisted of a duplex mixture ofaustenite and ε-martensite, but those of the other two steels were fully austenitic. The deformedmicrostructures were stu...
متن کاملObservation of Stacking Fault Tetrahedral in TWIP Steel
Low stacking fault energy face centered cubic (FCC) materials contain characteristic defect structures. Stacking fault tetrahedral are one of those rare structures that occur under special experimental conditions. For the first time, stacking fault tetrahedral were observed in Fe-30Mn-3Al-3Si twinning induced plasticity (TWIP) steel. Their presence resulted from a quenching heat treatment.
متن کاملULTRA FINE FERRITE FORMATION IN Si-Mn TRIP STEELS
Abstract: In the present investigation, the effects of thermomechanical processing parameters and the steel chemical composition on the ultra fine ferrite formation characteristics were studied. This was programmed relying on the capabilities of strain induced transformation (SIT) phenomenon and applying to different grades of Si-Mn TRIP (Transformation Induced Plasticity) steels. According...
متن کاملPrediction of Mechanical Properties of TWIP Steels using Artificial Neural Network Modeling
In recent years, great attention has been paid to the development of high manganese austenitic TWIP steels exhibiting high tensile strength and exceptional total elongation. Due to low stacking fault energy (SFE), cross slip becomes more difficult in these steels and mechanical twinning is then the favored deformation mode besides dislocation gliding. Chemical composition along with processing ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microscopy and Microanalysis
سال: 2011
ISSN: 1431-9276,1435-8115
DOI: 10.1017/s1431927611010312