Stability of LSM-Cathode (La0.8Sr0.2MnO3) Made by Screen Printing
نویسندگان
چکیده
منابع مشابه
Thickness Control of Piezoelectric Film Made by Stencil Printing
In various industries such as power plants, ultrasonic non-destructive testing (NDT) is widely used because of cost effectiveness and sub-surface defect/flaw detection capability. Piezoelectric films made of sol-gel composites could be useful as ultrasonic transducers due to high tempearature durability, reasonable signal strength, curved surface suitability, relatively low center frequency suc...
متن کاملHydroxyapatite scaffolds for bone tissue engineering made by 3D printing.
Nowadays, there is a significant need for synthetic bone replacement materials used in bone tissue engineering (BTE). Rapid prototyping and especially 3D printing is a suitable technique to create custom implants based on medical data sets. 3D printing allows to fabricate scaffolds based on Hydroxyapatite with complex internal structures and high resolution. To determine the in vitro behaviour ...
متن کاملThin Film Solar Cells by Screen Printing Technology
General properties of thin film solar cells and panels are discussed, and compared to crystalline silicon. A state-of-the-art of thin film cells and panels is given. One thin film production technique is elaborated: screen printing and sintering. The technique and its application to CdS/CdTe cells are presented. It is shown that sophistication to the basic technique can overcome inherent shortc...
متن کاملHighly efficient phosphorescent polymer OLEDs fabricated by screen printing
We demonstrate the use of screen printing in the fabrication of highly efficient phosphorescent polymer organic light-emitting devices (OLEDs) based on a green-emitting Ir(ppy)3 and a host polymer PVK. We incorporate PBD in the polymer host as an electron-transporting dopant and a-NPD as a hole-transporting dopant. The best screen-printed single-layer device exhibits very high peak luminous eff...
متن کاملFormaldehyde as Screen Printing Indoor Pollutant
The presence of formaldehyde in indoor air samples has been detected in five screen printing facilities of Novi Sad, Serbia. Air was sampled five times during one working week for each screen printing facility. The sampling was conducted continuously during 4 hours. The concentrations of formaldehyde were determined by UV-VIS spectrometry at 580 nm. The average concentrations of formaldehyde we...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ECS Proceedings Volumes
سال: 1997
ISSN: 0161-6374,2576-1579
DOI: 10.1149/199740.0907pv