Spinning Nozzles Manufactured by Electron Beam
نویسندگان
چکیده
منابع مشابه
Characterization of an Additive Manufactured TiAl Alloy—Steel Joint Produced by Electron Beam Welding
In this work, the characterization of the assembly of a steel shaft into a γ-TiAl part for turbocharger application, obtained using Electron Beam Welding (EBW) technology with a Ni-based filler, was carried out. The Ti-48Al-2Nb-0.7Cr-0.3Si (at %) alloy part was produced by Electron Beam Melting (EBM). This additive manufacturing technology allows the production of a lightweight part with comple...
متن کاملComparison of Quality of Bologna Sausage Manufactured by Electron Beam or X-Ray Irradiated Ground Pork
Ground lean pork was irradiated by an electron beam or X-rays to compare the effects of two types of radiation generated by a linear accelerator on the quality of Bologna sausage as a model meat product. Raw ground lean pork was vacuum packaged at a thickness of 1.5 cm and irradiated at doses of 2, 4, 6, 8, or 10 kGy by an electron beam (2.5 MeV) or X-rays (5 MeV). Solubility of myofibrillar pr...
متن کاملNanolithography by high energy electron beam
2014 The theoretical advantages of high energy beam (E0 = 100 keV) in electron lithography in the nanometer range ( 0.1 03BCm) are discussed. Using a Monte Carlo model, the different contributions at energy deposit in the PMMA resist are separated and the influence of each of them on the final resolution is analysed. Revue Phys. Appl. 23 (1988) JUILLET 1988, PAGE 1317 Classification Physics Abs...
متن کاملMeasurements of Photon Beam Flattening Filter Using an Anisotropic Analytical Algorithm and Electron Beam Employing Electron Monte Carlo
Introduction: This study aimed to report the measurement of photon and electron beams to configure the Analytical Anisotropic Algorithm and Electron Monte Carlo used in clinical treatment. Material and Methods: All measurements were performed in a large water phantom using a 3-dimensional scanning system (PTW, Germany). ...
متن کاملTreatment of Synthetic Textile Wastewater by Combination of Coagulation/Flocculation Process and Electron Beam Irradiation
Introduction: Textile wastewaters from dyeing and finishing processes are heavily polluted with dyes, textile auxiliaries and chemicals and have a broad range of pH, high COD concentration and suspended particles. In this study, the efficiency of color and turbidity removal from synthetic textile wastewater samples were investigated by combined process of coagulation/ flocculation and electron ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: SHINKU
سال: 1968
ISSN: 0559-8516,1880-9413
DOI: 10.3131/jvsj.11.356