Spike and disc forming test for friction measurement in cold forming of aluminium alloys
نویسندگان
چکیده
منابع مشابه
Numerical Modelling of Drawbeads for Forming of Aluminium Alloys
The drawbeads in stamping tools are usually designed based on experience from the forming of steel. However, aluminium alloys display different forming behaviour to steels, which is not reflected in the drawbead design for tools used for stamping aluminium. This paper presents experimental results from different semi-circular drawbead geometries commonly encountered in automotive dies and compa...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملStress Analysis and Energy Estimation in Cold-Roll Forming Process
In this article, stress analysis and energy estimation during cold-roll forming of symmetrical channel sections have been discussed. Geometry of sheet strip is pre-estimated by a shape function. Then longitudinal, transversal and shear strains have been calculated. Using both the Levy-Mises and the Prandtl Reuss equations, and also considering the Bauschinger effect, stress distributions have b...
متن کاملInvestigating the Effects of Cold Bulge Forming Speed on Thickness Variation and Mechanical Properties of Aluminum Alloys: Experimental and Numerical
In this work, cold bulge forming of an Aluminium-Magnesium (Al-Mg) sheet with a solid bulging medium is performed experimentally and numerically. Mechanical properties and thickness variations of Al-Mg sheet are evaluated before and after the forming process. The results indicated that the Al-Mg sheet has taken the desired shape without necking using the cold bulge forming process. Also, the...
متن کاملMultiscale Friction Modeling for Sheet Metal Forming
The most often used friction model for sheet metal forming simulations is the relative simple Coulomb friction model. This paper presents a more advanced friction model for large scale forming simulations based on the surface change on the micro-scale. The surface texture of a material changes when two surfaces are in contact under a normal load. This is caused by flattening due to combined nor...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indian Journal of Science and Technology
سال: 2011
ISSN: 0974-6846,0974-5645
DOI: 10.17485/ijst/2011/v4i6.11