Special issue/Plating on engineering plastics. Plated engineering plastics for automotive.
نویسندگان
چکیده
منابع مشابه
Joining of Carbon Fibre Reinforced Plastics for Automotive Applications
The introduction of carbon-fibre reinforced plastics in load bearing automotive structures provides a great potential to reduce vehicle weight and fuel consumption. To enable the manufacture and assembly of composite structural parts, reliable and cost-effective joining technologies must be developed. This thesis addresses several aspects of joining and load introduction in carbon-fibre reinfor...
متن کاملSemi-aromatic polyesters based on a carbohydrate-derived rigid diol for engineering plastics.
New carbohydrate-based polyesters were prepared from isoidide-2,5-dimethanol (extended isoidide, XII) through melt polymerization with dimethyl esters of terephthalic acid (TA) and furan-2,5-dicarboxylic acid (FDCA), yielding semi-crystalline prepolymers. Subsequent solid-state post-condensation (SSPC) gave high molecular weight (Mn =30 kg mol(-1) for FDCA) materials, the first examples of high...
متن کاملChallenges and Alternatives to Plastics Recycling in the Automotive Sector
Plastics are increasingly a preferred material choice in designing and developing complex, consumer products, such as automobiles, because they are mouldable, lightweight, and are often perceived to be highly recyclable materials. However, actually recycling the heterogeneous plastics used in such durable items is challenging, and presents very different scenarios to how simple products, such a...
متن کاملSpecial Issue for 13th International Industrial Engineering Conference (IIEC 2017)
This special issue is a collection of refereed articles selected from the 13th International Industrial Engineering Conference (IIEC 2017). The initial selection was made by Dr. Hamed Fazlollahtabar who also wrote the following description. The accepted articles were reviewed going through the usual reviewing process of IJOR. Nezam Mahdavi-Amiri Editor-in-Chief &nbs...
متن کاملBennington, Vermont Prepared by Barr Engineering for Saint-gobain Performance Plastics
Below are the initial comments of the Vermont Agency of Natural Resources (VT ANR) on the “Draft Interim Conceptual Site Model Site Investigation Report; Bennington, Vermont-December 2017,” prepared by Barr Engineering (Barr) for Saint-Gobain Performance Plastics. For the remainder of the comments the above-referenced report will be referred to as the SI report. VT ANR is sending you these comm...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Jitsumu Hyomen Gijutsu
سال: 1986
ISSN: 1884-3417,0368-2358
DOI: 10.4139/sfj1970.33.531