Spatial Control of Bacteria Using Screen Printing
نویسندگان
چکیده
منابع مشابه
A Stretchable Radio-Frequency Strain Sensor Using Screen Printing Technology
In this paper, we propose a stretchable radio-frequency (RF) strain sensor fabricated with screen printing technology. The RF sensor is designed using a half-wavelength patch that resonates at 3.7 GHz. The resonant frequency is determined by the length of the patch, and it therefore changes when the patch is stretched. Polydimethylsiloxane (PDMS) is used to create the substrate, because of its ...
متن کاملA Stretchable Electromagnetic Absorber Fabricated Using Screen Printing Technology
A stretchable electromagnetic absorber fabricated using screen printing technology is proposed in this paper. We used a polydimethylsiloxane (PDMS) substrate to fabricate the stretchable absorber since PDMS exhibits good dielectric properties, flexibility, and restoring capabilities. DuPont PE872 (DuPont, Wilmington, CT, USA), a stretchable silver conductive ink, was used for the screen printin...
متن کاملFormaldehyde as Screen Printing Indoor Pollutant
The presence of formaldehyde in indoor air samples has been detected in five screen printing facilities of Novi Sad, Serbia. Air was sampled five times during one working week for each screen printing facility. The sampling was conducted continuously during 4 hours. The concentrations of formaldehyde were determined by UV-VIS spectrometry at 580 nm. The average concentrations of formaldehyde we...
متن کاملVOC level control by ventilation improvement of Flexography printing room using CFD modeling
Using Computational Fluid Dynamics (CFD) technique, the dispersion contours and the exposure rate of Flexographic printing workers to VOCs in a printing department is evaluated. Firstly, VOCs distribution is determined in the printing room due to the existing ventilation system. Through next steps, 4 scenarios for lowering VOCs concentration and its exposure rate to workers are analyzed. Concen...
متن کاملBacterial printing press that regenerates its ink: contact-printing bacteria using hydrogel stamps.
This paper describes the use of micropatterned agarose stamps prepared by molding against PDMS masters to print patterns of bacteria on agar plates. Topographically patterned agarose stamps were inked with suspensions of bacteria; these stamps generated patterns of bacteria with features as small as 200 microm over areas as large as 50 cm2. Stamps with many small features (>200 microm) were use...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: 3D Printing and Additive Manufacturing
سال: 2016
ISSN: 2329-7662,2329-7670
DOI: 10.1089/3dp.2016.0040