Space Charge Measurement and Modelling in Cross-Linked Polyethylene
نویسندگان
چکیده
منابع مشابه
Space Charge Behavior in Low-Density Polyethylene
The space charge distribution in low-density polyethylene (LDPE) was measured with the pulsed electroacoustic (PEA) method. We used three types of LDPE: LDPE-L and LDPE-H were prepared by the high pressure process, and m-LDPE was polymerized with a metallocene catalyst. Space charge in LDPE strongly depended upon the electrode material. Semiconductive electrodes enhanced carrier injection into ...
متن کاملEvaluation of the Onset of Space Charge and Electroluminescence as a Marker for Cross-linked Polyethylene Ageing
The aim of the “ARTEMIS” project is to investigate the ageing mechanisms for cross-linked polyethylene under thermo-electrical stress and to identify ageing markers, which can be used to carry out diagnostic procedures. A carefully selected set of techniques which can give cross-correlated information on space charge phenomenology and material degradation were used to investigate specimens peel...
متن کاملCross-linked Polyethylene Engineered for TKA
Introduction It is well known that the wear resistance of ultra-high molecular weight polyethylene (UHMWPE) improves in proportion to the crosslinking irradiation dose. It is also well known that the mechanical properties and oxidative stability of UHMWPE are affected by the irradiation dose, resin type, and post-irradiation heat treatment, among others factors. Therefore, careful consideration...
متن کاملSpace-charge dynamic in polyethylene: from dc to ac stress
Time-resolved space charge profiles obtained in low density polyethylene under sinusoidal or square AC stress for frequencies going from DC to 10 Hz, temperature from 25 to 50°C and fields of 30 or 40 kV/mm are presented. It is shown that most of the features observed under DC stress (generation of carriers of the two polarities with non-symmetrical amount and velocity) are still active under A...
متن کاملWear of moderately cross-linked polyethylene fixed bearing knee replacements
Cross-linked polyethylene has been explored as an alternative to conventional polyethylene in total joint replacement in order to reduce wear volume and decrease failure through polyethylene wear debris induced osteolysis [1]. Due to the demands of a total knee replacement, moderately cross-linked polyethylene is recommended to retain mechanical properties [2]. This study aims to investigate th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Energies
سال: 2020
ISSN: 1996-1073
DOI: 10.3390/en13081906