SOPC design of an impedance analyser without current measurement
نویسندگان
چکیده
منابع مشابه
design of an analog fuzzy logic controller chip
fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...
15 صفحه اولFault Location on Compensated Transmission Lines without Current Measurement
This paper presents a novel fault location method for series compensated transmission lines. It is established based on synchronized voltages sampling and Thevenin impedance from both ends of series compensated transmission line. The method is based on the use of phasor measurement units (PMU) technology which is aimed to be independent of current measurements, fault type, fault resistance, fau...
متن کامل3-D Camera SoPC Design Architecture
It is often seen that the available knowledge base within an organisation influences the selection of the design platform. The two major contenders for signal processing hardware platforms are DSP processor and FPGA. DSP processor offers high compute intensive complete embedded product where as FPGA offers high flexibility to a System on Programmable Chip (SoPC) designer for proof of concept at...
متن کاملOffset-free bidirectional current source for impedance measurement
In order to minimize the influence of electrode polarization and noise in impedance measurements, especially in the low frequency region, current injection shows several advantages compared to voltage application. Although the existence of a great variety of current sources, they meet our requirements only partially. We developed a voltage controlled current source for active front ends for a w...
متن کاملDesign Modification of Rogowski Coil for Current Measurement in Low Frequency
The principle object of this paper is to offer a modified design of Rogowski coil based on its frequency response. The improvement of the integrator circuit for nullifying the phase difference between the waveforms of the measured-current and the corresponding terminal voltage is a further object of this investigation. This paper addresses an accurate, yet more efficient measuring and protect...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2010
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2010.09.269