Some Consideration on Carbide Tool Wear in Dry Cutting of Silumin
نویسندگان
چکیده
منابع مشابه
Evaluation of Flank Wear of Iron-rich Binder Carbide Cutting Tool in Turning of Titanium Alloy
Despite the fact that Titanium material has been considered as difficult to cut material, its usage has been increasing day by day in all engineering sectors; wherever criticality is encountered. Many studies are going on in view of increasing tool life at high cutting speed to improve productivity. In this study, attempt has been made to see the effect of iron as a partial substitution along ...
متن کاملCheck Tic-coated Tungsten Carbide Tool Wear in Machining Steel
In industrial production systems, including the most important factors in the economic field machining operations, reduce tool wear due to abrasive nature of the phenomenon on many factors, including temperature Lathe tool, influences, machining conditions (cutting speed, speed losses, forcing to rebuild parts of the manufacturing tolerances disassemble tool wear is caused by the phenomenon, as...
متن کاملWear and tool life of tungsten carbide, PCBN and PCD cutting tools
The wear mechanisms of cutting tools made of tungsten-carbide (WC), PCBN and PCD were investigated using the tool life and temperature results available in the literature. For tool/work combinations WC/steel and PCBN/hardened-steel, under practical conditions, tool wear was found to be greatly influenced by the temperature. It was concluded that the most likely dominant tool wear mechanism for ...
متن کاملCutting tool wear estimation for turning
The experimental investigation on cutting tool wear and a model for tool wear estimation is reported in this paper. The changes in the values of cutting forces, vibrations and acoustic emissions with cutting tool wear are recoded and analyzed. On the basis of experimental results a model is developed for tool wear estimation in turning operations using Adaptive Neuro fuzzy Inference system (ANF...
متن کاملEffect of Cutting Parameters on Tool Wear, Surface Roughness and Material Removal Rate During Dry Turning of EN-31 Steel
ISBN 978-93-82338-21-5 | © 2012 Bonfring Abstract--The present paper is an experimental study to investigate the effect of cutting parameters (cutting speed, depth of cut and feed) on tool wear, surface roughness and material removal rate (MRR) during dry turning of EN-31 steel. Turning experiments were conducted with cutting speeds: 250, 300, 350 m/min, feeds: 0.15, 0.2, 0.25 mm/rev and depth ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1982
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.46.6_657