Solution for strain-softening surrounding rock reinforced by grouted bolts
نویسندگان
چکیده
منابع مشابه
Constitutive Modeling of Rocks, Rock Joints and Rock Masses including Strain Softening Behaviour
The rocks are formed through very complex processes and the complex behaviour of rock masses is dominated by the planes of weaknesses . Rock mass consists of intact rock and discontinuities. Many rocks show strain softening behaviour under loads. In this paper, the constitutive models for intact rocks and rock joints are presented. These form the basis for the development of constitutive models...
متن کاملEfficient Solution for Composites Reinforced by Particles
A very effective method for some kind of problems is the Method of Fundamental Solutions (MFS). It is a boundary meshless method which does not need any mesh and in linear problems only nodes (collocation points) on the domain boundaries and a set of source functions (fundamental solutions, i.e. Kelvin functions) in points outside the domain are necessary to satisfy the boundary conditions. Ano...
متن کاملTension Softening Behavior of Fiber Reinforced Concrete
The project aims to study tensile softening behavior of fiber reinforced concrete .Concrete is very much weak in tension but by addition of randomly oriented short crimped steel fibers will change the behavior from brittle to ductile. In the present work, the steel fibers were added at the volume fraction, being 0%, 0.5%, 1%, 1.5% to the normal strength concrete and high strength concrete. The ...
متن کاملAnalysis of Circular Reinforced Tunnels by Analytical Approach
This paper addresses the problem of quantifying the mechanical contribution of rockbolts installed systematically around tunnels (regularly spaced around the tunnel) excavated in rock masses. Assuming that the mechanical contribution of grouted rockbolts is that of increasing internal pressure within a broken rock mass, a new procedure for computation of ground response curves for a circular tu...
متن کاملShear Localization due to Strain Softening in Side Pressed Cylinders
In this paper, shear localization due to strain softening in sidepressed cylinders, is inverstigated. Shear localization causes formation of macroscopic shear bands which can be obsserved in the metallographic cross-section. In this paper, for the first time a method is presented in which a simple two-slice model is used to study the formation of shear bands. The results obtained form this mode...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Advances in Mechanical Engineering
سال: 2017
ISSN: 1687-8140,1687-8140
DOI: 10.1177/1687814017697280