Solid State Pressure Welding of Superplastic Zn-22Al Alloy
نویسندگان
چکیده
منابع مشابه
Properties in Tension of Semi Continuous Cast and Extruded Zn-22Al-2Cu alloy
Circular bars of the Zn-22Al-2Cu alloy were prepared by utilizing the semi continuous vertical casting technique. Solid as cast showed high values in the mechanical strength (497 MPa) and hardness (71 RB). The micro structure of the bars consisted of equiaxed dendrites with eutectoidal composition surrounded by eutectic. At higher magnifications it can be observed that dendrites are two-phase e...
متن کاملSuperplastic Forming of Inconel Alloy 718spf
Superplasticforming (SPF) has become an important manufacturing method for aerospace and fuselage components. The basic reasons for the popularity of this process are reviewed and the compatibilityoffine-grained INCONELB alloy71 8SPF@ to superplasticforming are presented in this paper. The temperature limitations of current aluminum and titanium alloys employed in SPF parts for gas turbine comp...
متن کاملJoining of Al 6061 alloy to AISI 1018 steel by combined effects of fusion and solid state welding
The joining of a 6-mm thickness Al 6061 to AISI 1018 steel has been performed by the combined effects of fusion and solid state welding. The process is derived from friction stir welding (FSW) but with an adjustable offset of the probe location with respect to the butt line. Metallographic studies by optical microscopy, electron probe microscopy, and the utilization of the X-ray diffraction tec...
متن کاملTowards Superplastic Forming of Az31 Magnesium Alloy with Controlled Microstructure
A recent study on post-superplastic forming properties has shown that heating time prior to testing has a major effect on the post-forming properties of superplastically-formed AZ31 Magnesium alloy sheets. To this point, there has been very little examination into the effects of pre-heating or annealing on superplastic forming. In this work, these effects are examined using AZ31 Mg alloy sample...
متن کاملSuperplastic hemispherical Bulge Forming of a Ti-Al-Mn Alloy
Superplastic sheet thermoforming has been identified as a standard processing route for the production of complex shapes, especially in the aerospace industry. Ti-Al-Mn (OT4-1) alloy is currently being used for aero engine components as well as other aerospace applications by forming through a conventional route which is typically cost, labour and equipment intensive. The Ti-Al-Mn alloy (made a...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1985
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.49.7_552