Solid lubricating coatings tribological test rig development
نویسندگان
چکیده
منابع مشابه
CrN–Ag self-lubricating hard coatings
CrN–Ag composite films, 2.5–4 Am thick, were deposited by reactive magnetron sputtering on Si and stainless steel substrates in a 0.4 Pa pure nitrogen atmosphere at 500 -C. The layer composition was controlled by the relative power to 7.5-cm-diameter Ag and Cr targets to be 0, 3, 12, and 22 at.% Ag. The layers exhibit a dense columnar microstructure where the Ag is homogeneously distributed in ...
متن کاملDevelopment of a Test-rig for a Modern Motorcycle Engine
This paper presents experimental activities that have been performed in the Automotive Engineering Centre laboratories in Universiti Malaysia Pahang for developing a test-rig based on a modern motorcycle engine. The experimental engine test-rig was developed based on an eddy current dynamometer which was coupled to a four-stroke singlecylinder SI motorcycle engine. Moreover, the test-rig consis...
متن کاملSelf-lubricating, low-friction, wear-resistant Al-based quasicrystalline coatings
After gas atomization, a quasicrystalline powder based on aluminium was used to prepare a thick coating by high-velocity oxygen-fuel flame torch spraying. This layer was deposited on top of a bond-coat layer on a steel plate. A post-spraying annealing treatment turned the two layers to their stable state, a γ-brass crystal and an icosahedral quasicrystal, respectively. The projection parameters...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/1129/1/012029