Softening Kinetics of Plain Carbon Steels Containing Dilute Nb Additions
نویسندگان
چکیده
منابع مشابه
تاثیر ترکیب شیمیایی بر تحولات ریزساختاری فولادهای میکروآلیاژی در حین تغییر شکل گرم در منطقه دو فازی (آستنیت + فریت)
Laboratory hot torsion testing technique was carried out on one plain low carbon steel and two plain low carbon Nb and Nb-Ti micro alloyed steels to study the effects of chemical composition, micro alloying addition, on the dynamic softening and grain refinement of ferrite during warm deformation. Deformation schedule was conducted within two phase region (i.e. between Ar3-Ar1). The physical pr...
متن کاملSTRAIN INDUCED AUSTENITE-TO-FERRITE TRANSFORMATION BEHAVIOR OF PLAIN CARBON STEELS THROUGH SINGLE PASS ROLLING
In principal, a proper combination of strength and ductility is achieved through micro component refinement in steels. This is particularly empowered with ferrite refinement down to micron sizes in ferrite pearlite engineering steels. The latter is achieved through various well-defined methods in which strain induced transformation (SIT) has shown spectacular capabilities. In the present study,...
متن کاملPREDICTION OF CRITICAL STRESS AND STRAIN FOR THE ONSET OF DYNAMIC RECRYSTALLIZATION IN PLAIN CARBON STEELS
The aim of the present study is the prediction of critical conditions (including critical strain and flow stress) for the initiation of dynamic recrystallization during thermo-mechanical processing of plain carbon steels. For this propose, torsion tests were conducted at different temperature (1050, 1100 and 1150˚C) and strain rates (0.002, 0.02 and 0.2/s). All flow curves showed a peak st...
متن کاملOptimization of Mechanical Properties of High-Carbon Pearlitic Steels with SI and V Additions
continuous grain-boundary cementite can form and cause THE primary requirements for high-strength wire appliembrittlement.[4,5] Nevertheless, we have found that it is cations are tensile strength, ductility, and formability. Coldpossible to use pearlitic steels with carbon contents greater drawn plain-carbon pearlitic steels have commonly been than 0.8 wt pct without the formation of a continuo...
متن کاملVariation of Transition Temperatures from Upper to Lower Bainites in Plain Carbon Steels
Experimental results and explanations for the transition temperature from upper to lower bainites in carbon steels containing from 0.20 to 1.80 wt%C were presented metallographically and kinematically. The experimental results are summarized as follows: I) Lower bainite is not formed in steels with less than 0.35 wt%C and no transition from upper to lower bainite occurs. 2) The transition tempe...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science Forum
سال: 2016
ISSN: 1662-9752
DOI: 10.4028/www.scientific.net/msf.879.1546