SOFT MAGNETIC PROPERTIES OF Mg0.7-xNi0.3ZnxFe2O4 FERRITES SYNTHESIZED BY SOL-GEL AUTO-COMBUSTION TECHNIQUE WITHOUT POST-PREPARATION THERMAL TREATMENT
نویسندگان
چکیده
منابع مشابه
Microstructure and Magnetic Properties of Sr2Co1.7Mg0.3Fe11.2 Hexaferrite Synthesized by Auto-Combustion Sol-Gel Method
A single phased Y-type hexagonal ferrite Sr2Co1.7Mg0.3Fe11.2Sn0.4Zn0.4O22 was synthesized by the sol–gel auto combustion method. Structural and magnetic properties of this composition of Y-type hexagonal ferrite have been investigated. The X-ray diffraction (XRD) patterns confirm single phase Y-type hexagonal ferrite and various parameters such as lattice constants and cell volume have been cal...
متن کاملMagnetic Properties of Sr-Ferrite Nano-Powder Synthesized by Sol-Gel Auto-Combustion Method
In this paper, strontium ferrite (SrO.6Fe2O3) was synthesized by the sol-gel auto-combustion process. The thermal behavior of powder obtained from self-propagating combustion of initial gel was evaluated by simultaneous differential thermal analysis (DTA) and thermo gravimetric (TG), from room temperature to 1200°C. The as-burnt powder was calcined at various temperatures from 700-900°C to achi...
متن کاملPhase Formation, Microstructure and Magnetic Properties of BiFeO3 Synthesized by Sol-Gel Auto Combustion Method Using Different Solvents
In this research nano particles of bismuth ferrite (BiFeO3) were synthesized by sol-gel auto-combustion route. The effect of water and ethylene glycol solvents were studied on phase constituents, magnetic properties and microstructure of the bismuth ferrite by X-ray diffraction (XRD), scanning electron microscope (SEM) and vibration sample magnetometer (VSM) techniques. XRD resul...
متن کاملStructural, Magnetic and Acetone Sensing Properties of Barium- Calcium Hexaferrite Synthesized by Sol- Gel Auto Combustion Method
In this research, barium calcium hexaferrite (Ba1-xCaxFe12O19 , 0≤x£1) nanoparticles were synthesized through a sol-gel combustion method. The dried gel samples were then calcined at 950ᵒC for 4:30h. The phase and microstructural evolution of calcined samples were investigated by X-ray powder diffraction (XRD) and scanning electron microscopy (SEM), respectively. The results revealed formation ...
متن کاملPreparation and Evaluation of NiFe204 and CuFe204 Nanoeatalysts by Combination of Sol- Gel Auto-Combustion Method and Irradiation Technique
The dried nitrate-urea gels exhibit the combination of autoicatatric combustion behavior and ultrasonic, whichcan be used to synthesize the nanocatalyst ferrite powders. Cu and Ni Unites nanocatalyst powders sithcomposition of Caned], and NiFe204 were synthesized by a sol-gel auto catalnic combustion process. Themolar ratio between metal ions and urea was 11.2. The sob gel process was done at 8...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Modern Physics: Conference Series
سال: 2013
ISSN: 2010-1945,2010-1945
DOI: 10.1142/s2010194513009896