Slow strain rate tension tests under hydrogen evolution potential on SUS430 stainless steel with different surface roughness.
نویسندگان
چکیده
منابع مشابه
The Interaction between Hydrogen and Surface Stress in Stainless Steel
This paper reveals the interaction between hydrogen and surface stress in austenitic stainless steel by X-ray diffraction stress measurement and thermal desorption analysis before and after being charged with hydrogen. The surface residual stress was varied by surface finishing using several disc polishing agents. The obtained results show that the residual stress near surface had a significant...
متن کاملEffect of surface roughness on steel-steel dry friction coefficient
The influence of surface roughness magnitude and direction on dry static friction coefficient between two similar steel samples has been studied through an experiment. A testing apparatus has been designed and fabricated to measure the friction coefficient for a few forms of surface asperity. According to the results of the experiments, dry friction coefficient is affected by both magnitude and...
متن کاملLattice strain evolution during uniaxial tensile loading of stainless steel
Applied and residual lattice strains were determined by neutron diffraction during a tensile test of a weakly textured austenitic stainless steel and were compared to the predictions of a self-consistent polycrystal deformation model. Parallel to the tensile axis the model predictions are generally within the resolution of the diffraction measurements, but perpendicular to the tensile axis disc...
متن کاملStress–strain response and microstructural evolution of a FeMnCAl TWIP steel during tension–compression tests
The stress–strain response of a Fe–17.5Mn–0.7C–2Al TWIP steel during cyclic loading has been investigated by means of tension–compression tests within the strain limits of 72%, 75% and 710%. In addition, the microstructural evolution during the 75% cyclic test has also been studied. The difference between the forward and reverse stress for each pre-strain has been analyzed at 0.2% offset strain...
متن کاملThe Effect of Surface Roughness on the Fretting Corrosion of 316l Stainless Steel Biomaterial Surfaces
The medical device industry is still seeking answers to the mechanically-assisted corrosion (MAC) problem, which becomes increasingly important due to modularity in design. MAC manifests in various forms, some of which are fretting corrosion, crevice corrosion and stress corrosion. Several studies have been conducted to understand the causes and the factors that affect fretting corrosion. Some ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Society of Materials Science, Japan
سال: 1990
ISSN: 1880-7488,0514-5163
DOI: 10.2472/jsms.39.1026