Slip Casting and Sintering of Y-PSZ(Part 2)-Slip Casting and Sintering.
نویسندگان
چکیده
منابع مشابه
The effect of slip casting parameters on the ultrafine microstructure and density of pore-free YAG ceramic obtained by vacuum sintering
In this study, the effect of slip casting parameters on the ultrafine microstructure and the density of pore-free YAG ceramic was evaluated. A stable, high concentrated aqueous YAG slurry using Dolapix-CE64 as a dispersant was prepared. The effect of dispersant concentration as well as the solid load on the stability and rheological behavior of the slurry was also studied. The optimal dispersan...
متن کاملComplex-Shaped Porous Cu Bodies Fabricated by Freeze-Casting and Vacuum Sintering
Porous Cu bodies with complex shapes were fabricated by freeze-casting and vacuum sintering water-based CuO slurry. The sintered bodies showed no noticeable macroscopic defects and good shape tolerance. The interconnected pore tunnels were observed by electronic microscopy. The pore size became smaller and the porosity and volume shrinkage of sintered porous bodies decreased with the increase o...
متن کاملDevelopment of nano-grained Calcium Hy-droxyapatite using slip casting technique
The purpose of this study is to synthesize nano-grained Calcium Hydroxyapatite (HAp) through slip casting technique. For this, hydroxyapatite powders were synthesized using two methods, wet chemical method and Ammoniacal method. The as-prepared powders and calcined powders were characterized using XRD, FTIR, to study the phases of the powders. The hydroxyapatite powder calcined at 1000°C for 2h...
متن کاملPreparation and Evaluation of Porous ƒÀ - TCP Based Composites
The scaffolds composed of monolithic ƒÀ-TCP and ƒÀ-TCP/ƒ¿-TCP composites were fabricated by a low-loaded environmental processing. The pore introduction was attempted using starch, instead of polymer beads. The aqueous slurry of the mixture of ƒÀ-TCP and starch was prepared for an aqueous slip-casting. Problem on the heterogeneity distribution of the starch in aqueous slip-casting was solved by...
متن کاملComparative study between laser sintering and casting for retention of resin composite veneers to cobalt-chromium alloy.
The purpose of this study was to evaluate and compare the bond strengths between resin composite veneer and laser-sintered cobalt-chromium (Co-Cr) alloy with and without retention devices (Laser-R and Laser-N respectively). Cast Co-Cr alloy with and without retention devices (Cast-R and Cast-N respectively) were also prepared for fabrication technique comparison. Disk-shaped Co-Cr alloy specime...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 1999
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.46.1058