Sliding wear behavior of fully nanotwinned Cu alloys
نویسندگان
چکیده
منابع مشابه
Dry Sliding Wear Behavior of Epoxy-Rubber Dust Composites
Composite pins of rubber dust collected from tyre retreading centres of trucks, cars and buses etc.and epoxy with weight percentages of 10. 15, and 20 % of rubber (weight fractions of 9, 13 and 17 % respectively) have been prepared in house with the help of a split wooden mould. The pins were tested in a pin-on-disc wear monitor to determine the co-efficient of friction and weight losses with v...
متن کاملThe Wear Behavior of Textured Steel Sliding against Polymers
Artificially fabricated surface textures can significantly improve the friction and wear resistance of a tribological contact. Recently, this surface texturing technique has been applied to polymer materials to improve their tribological performance. However, the wear behavior of textured tribo-pairs made of steel and polymer materials has been less thoroughly investigated and is not well under...
متن کاملEffects of Doping Elements on the Friction and Wear of SUJ2 Steel Sliding against Aluminum Alloys
Damage to mechanical components caused by wear is considered to be an important issue for mechanical engineers. For the purpose of wear resistance, it is necessary to improve the material properties of the mechanical elements. Furthermore, low friction plays an important role in saving energy. Hence, it is important to establish a key technology for wear resistance and low friction through appr...
متن کاملThe Dry Sliding Wear Properties of Nano-Sized TiCp/Al-Cu Composites at Elevated Temperatures
Nano-sized ceramic particle reinforced aluminum composites exhibit excellent room-temperature mechanical properties. However, there is limited research on the dry sliding wear behavior of those composites at elevated temperatures, which should be one of the major concerns on elevated temperature applications. Here the Al-Cu composites reinforced with nano-sized TiCp were fabricated. The dry sli...
متن کاملInvestigation on Wear Behavior of W-Cu Nanocomposite Fabricated Through Thermochemical Synthesis
In this work, homogeneous thermochemical co-precipitation method was used to fabricate W-25wt%Cu nanocomposite. Synthesized nanocomposite powder was calcined and reduced. A hydrogen atmosphere sintering at 1200oC for 105 consolidated the product up to a density close to 98% theoretical density. Wear experiment were carried out using a pin-ondisc set up at three normal loads of 5, 10 and 15 N an...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Friction
سال: 2018
ISSN: 2223-7690,2223-7704
DOI: 10.1007/s40544-018-0220-z